Anselmo Cola TOPFIRE 80 Manual De Instalación, Uso Y Mantenimiento página 57

Movement of auction
SLOT for inserting control
ROD and SELECTION lock
4.6 Idle period (end of season)
If the insert is not used for long periods, and/or at the end of each season, it is advisable to proceed as follows
- remove all the pellets from the hopper;
- disconnect the power supply by disconnecting the power cable or by using the external switch;
- clean thoroughly and, if necessary, have any damaged parts replaced by qualified personnel;
- in case of removal of the insert, arrange it in a safe and dry place, protected from the atmospheric agents.
5 CLEANING THE INSERT
Cleaning the insert is very important to ensure proper operation and to prevent: blackening of the glass, poor
combustion, deposits of ash and unburnt products in the brazier, reduced thermal efficiency.
The insert must operate only and exclusively with the fire door closed.
The fire door seals must be checked periodically to prevent any air from entering; the combustion chamber and
pellet duct work in a negative pressure and the fume exhaust in a positive pressure.
Routine cleaning is normally carried out by the customer following the instructions in the manual, whereas
extraordinary maintenance, at least once a year, must be carried out by the authorized Service Center.
- Cleaning operations for all parts must be carried out with the insert cold and
electrically disconnected;
- Dispose of cleaning waste in accordance with the current local regulations;
- Avoid the creation of smoke and unburnt products during lighting and/or normal
operation.
Given below are the control and/or maintenance operations for proper use and operation of the insert.
Parts / Period
Type of cleaning
Brazier
Ash compartment-pan
Glass
Baffle - fume exchanger
–
Manifold fume extractor
Glass - door seal
Pipe - flue connection
Remote control batteries
5.1 Cleaning the brazier
Remove the brazier and the ash deposited in the combustion chamber and brazier holder. A suitable vacuum
cleaner may be used for this purpose. This operation must be carried out daily, especially in case of accumulated
unburnt matter, to ensure perfect combustion conditions, since the brazier holes allow the flow of combustion air.
Position release
2-3 days
1 day
routine
routine
cleaning
cleaning
■
■
■
Control ROD
2 - 3
1 month
months
routine
routine
cleaning
cleaning
■
■
57
1st
reference
2nd
reference
3rd
reference
4th
reference
1 year
extraordinary cleaning:
done by the Service Center
■
■
■
■
■
TOPFIRE 80 canalizzabile