Description - Hilti PR 3 Manual De Instrucciones

1.2 Explanation of the pictograms and other
information
Symbols
Read the General
operating warning
instructions
before use.
For indoor Warning:
use only caustic
substances
Symbol for Laser Class II / Class 2
Laser class II Laser class 2
according to according to
CFR 21, § 1040 EN 60825:2008
(FDA)

2 Description

2.1 Use of the product as directed
The Hilti PR 3 is a laser tool with a rotating laser beam and a reference beam set at 90° to the main beam.
The tool is designed to be used for determining, checking / transferring levels, verticals, alignment, slopes and right
angles, for example: transferring datum lines and heights, marking out partition walls (vertical and/or at right angles)
or aligning equipment and components in three axes.
Use of tools or AC adapters which show visible signs of damage is not permissible.
Operation outdoors or in damp conditions in "Charging during operation mode" is not permissible.
Hilti supplies various accessories which allow the tool to be used with maximum efficiency.
The tool and its ancillary equipment may present hazards when used incorrectly by untrained personnel or when used
not as directed.
To avoid the risk of injury, use only genuine Hilti accessories and insert tools.
Observe the information printed in the operating instructions concerning operation, care and maintenance.
Take the influences of the surrounding area into account. Do not use the appliance where there is a risk of fire or
explosion.
Modification of the tool is not permissible.
2.2 Features
The tool allows a single person to level or align in any plane quickly and with great accuracy. Automatic leveling (within
±5°): The tool levels itself automatically after switching on. LEDs indicate the tool's current operating status. The tool
can be set up directly on the floor, on a tripod, or with the aid of suitable mounting brackets.
The preset speed of rotation is 300 /min.
>1/4s
Return waste Do not look
material for into the
recycling. beam.
Warning: Revolutions
electricity per minute
Type identification plate
PR 3
Po = average radiant power of a pulsating laser, laser
wave length 620-690nm, modulation frequency 1 MHz,
pulse cycle 50%, diameter of bundled laser beam at
the pentaprism 5mm, speed of rotation 300 /min. Under
the conditions listed above, the average output power is
<4.85 mW.
Location of identification data on the tool
The type designation and serial number can be found on
the type identification plate on the tool. Make a note of
this data in your operating instructions and always refer
to it when making an enquiry to your Hilti representative
or service department.
Type:
Generation: 01
Serial no.:
PR 3
en
15