Amplicomms PowerTel 97 Alarm Manual De Instrucciones página 113

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

G
ETTING STARTED
Then connect the telephone receiver to the base unit. Take one end of the spi-
ral cable and plug it into the socket at the bottom of the receiver. Plug the other
end of the spiral cable into the socket on the side of the phone.
Connect the telephone cable supplied to the telephone socket and the jack on
the rear side of the telephone. Feed the cable through the respective cable
channel.
If you want to use the telephone as a table
unit, mount the table support on the
bottom side of the device. The notch of the
table support is located above the upper wall
mounting facility (see figure).
Make sure that all four of the locking hooks
are correctly locked in place.
Helpline UK 0844 800 6503
110
(See page 148 for costs and hours of operation)

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido