Troubleshooting - Ryobi RY14110 Manual Del Operador

IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CONTACT YOUR AUTHORIZED SERVICE DEALER.
PROBLEM
Handle not in position
Mower not starting
Mower cutting grass unevenly
Mower not mulching properly
Mower hard to push
Mower not bagging properly
Mower vibrating at higher speed
Mower doesn't self-propel
Motor stops while cutting

TROUBLESHOOTING

POSSIBLE CAUSE
Carriage bolts not seated properly.
Handle knobs not tightened.
Battery is low in charge.
Battery is either inoperable or will not
take a charge.
Lawn is rough or uneven or cutting
height not set properly.
Wet grass clippings sticking to the un-
derside of the deck.
High grass, rear of mower housing and
blade dragging in heavy grass, or cut-
ting height too low.
Cutting height set too low
Blade is unbalanced, excessively or
unevenly worn.
Bent motor shaft.
Cutting height set too low
MAKE THE MOST OF YOUR PURCHASE!
Go to http://register.ryobitools.com and register your new tool on-line.
Your product has been fully tested prior to shipment
to ensure your complete satisfaction.
For any questions about operating or maintaining
your product, call the Ryobi Help Line!
13 — English
SOLUTION
Adjust the height of the handle and
make sure the carriage bolts are seated
properly.
Tighten handle knobs.
Charge the battery.
Replace the battery.
Move the wheels to a higher position.
All wheels must be placed in the same
cutting height for the mower to cut
evenly.
Wait until the grass dries before mow-
ing.
Raise cutting height.
Raise cutting height.
Replace the blade.
Stop the motor, remove fuse key and
battery, disconnect the power source,
and inspect for damage. Have repaired
by an authorized service center before
restarting.
Take the mower to an authorized service
center.
Raise the cutting height