Emptying The Container; At The End Of A Cleaning Session; Maintenance, Cleaning And Decontamination - Nilfisk cfm 118 Manual De Instrucciones

Emptying the container

WARNING!
Before proceeding with these operations, turn
off the vacuum cleaner and remove the plug
from the power socket.
- Before emptying the container it is advisable
to clean the filter (see "Shaking the main filter"
paragraph).
- Release the dust container "A" (fig. 10), then
remove and empty it.
- Make sure that the gasket is in perfect condition
and correctly positioned.
- Place the container back in position and secure it
again.
Plastic bag
A plastic bag can be used to collect dust (code 8
40099) (see fig. 8).
In this case, the vacuum cleaner must be equipped
with optional accessories (depressor and grid - fig. 8).
Paper bag
A paper bag "A" - fig. 9 can be used to collect dust. In
this case, the vacuum cleaner must be equipped with
optional accessories (dust container "B" and plug "C" -
fig. 9).
WARNING!
-
These operations can only be carried out by
trained and qualified personnel who must
wear adequate clothing, in compliance with
the laws in force.
- Take care not to raise dust when this
operation is carried out. Wear a protective
mask.
- In order to dispose of dusts that are
dangerous and/or hazardous to health, a
plastic bag (code 40100) or an ABS safety
container (code 8 30202 - 8 31685) can be
used.
- The container and/or bag must only be
disposed of by qualified personnel and in
compliance with the laws in force.
How to replace the safety container
- Place the vacuum hose in a safe and dust-free
place;
- release the dust container "I" (fig. 13);
- close the safety container with the supplied cover,
remove it from the dust container "I" (fig. 13), and
replace it with an empty one.
- Start the motor again to prevent dust from being
blown about.
- Make sure that the gasket is in perfect condition
and correctly positioned.
- Switch off the motor, fit an empty container in
place and fasten it in position.
02/2013

At the end of a cleaning session

1. Turn off the vacuum cleaner and remove the plug
from the socket.
2. Wind the connection cable (fig. 14).
3. Empty the container as described in the "Emptying
the container" paragraph. Clean the vacuum
cleaner as described in the "Maintenance,
cleaning and decontamination" paragraph.
4. Wash the container with clean water if aggressive
substances have been vacuumed.
5.
Store the vacuum cleaner in a dry place, out of
reach of unauthorized people.
Maintenance, cleaning and
decontamination
WARNING!
The precautions described below must be taken
during all maintenance operations, including
cleaning and replacing the primary and HEPA
filters.
WARNING!
The maintenance, cleaning and
decontamination operations must only be
performed with the vacuum cleaner turned
off and the plug disconnected from the power
socket.
It is absolutely forbidden to perform
maintenance with the plug connected to the
socket.
Danger of electric shock!
- If the user is performing the maintenance
operations, the vacuum cleaner must be
disassembled, cleaned and overhauled as far
as reasonably possible without hazards for the
maintenance personnel or other people. The
suitable precautions include decontamination
before disassembling the vacuum cleaner,
adequate filtered ventilation of the exhaust
air from the room in which it is disassembled,
cleaning the maintenance area and suitable
personal protection.
9
118
US
C384