Hitachi CS 36DL Manual De Instrucciones página 25

4. Cleaning the guide bar (Figs. 6, 40)
When sawdust and similar become clogged
in the groove of the guide bar or oil spout, the
oil may not fl ow, which may result in the unit
failing.
Remove the guide bar and clean any sawdust
clogged in the groove after use and when
replacing the saw chain. (Refer to "Installing
(replacing) saw chain.")
5. Inspecting the carbon brushes (Fig. 41)
The motor employs carbon brushes which
are consumable parts. Since and excessively
worn carbon brush can result in motor trouble,
replace the carbon brush with new ones when
it becomes worn to or near the "wear limit". In
addition, always keep carbon brushes clean
and ensure that they slide freely within the
brush holders.
0.45" (11.5 mm)
NOTE
When replacing the carbon brush with a new
one, be sure to use the Hitachi Carbon Brush
Code No. 999068.
6. Replacing carbon brushes
Take out the carbon brush by fi rst removing
the brush cap and then hooking the protrusion
of the carbon brush with a slotted head screw
driver, etc., as shown in Fig. 42.
When installing the carbon brush, choose the
direction so that the nail of the carbon brush
(see Fig. 43) agrees with the contact portion
of brush tube. Then push it in with a fi nger as
illustrated in Fig. 44. Lastly, install the brush
cap.
Brush cap
Chain oil spout
Groove
Guide bar
Oil hole
Fig. 40
Wear limit
0.12" (3 mm)
Fig. 41
Fig. 42
Nail of carbon brush
Protrusion of carbon brush
Contact portion of brush tube
CAUTION
● Be absolutely sure to insert the nail of the
carbon brush into the contact portion of
brush tube. (You can insert whichever one
of the two nails provided.)
● Caution must be exercised since any error
in this operation can result in the deformed
nail of the carbon brush and may cause
motor trouble at an early stage.
7. Disposal of the exhausted battery
WARNING
Do not dispose
battery. The battery must explode if it is
incinerated. The product that you have
purchased contains
battery. The battery is recyclable. At
the end of it's useful life, under various
state and local laws, it may be illegal to
dispose of this battery into the municipal
waste stream. Check with your local solid
waste offi cials for details in your area for
recycling options or proper disposal.
8. Storage
Storing in a place below 104°F (40°C) and out
of the reach of children.
NOTE
Make sure that the battery is fully charged
when stored for a long period (3 months or
more). The battery with smaller capacity may
not be able to be charged when used, if stored
for a long period.
NOTE
Storing Lithium-ion Batteries
Make sure the lithium-ion batteries have been
fully charged before storing them.
English
Fig. 43
Fig. 44
of the exhausted
a rechargeable
25