Questions?
PROBLEM
Use this
FAN DOES NOT
OPERATE WHEN
problem
THE ON/OFF BUTTON
solver!
IS PUSHED
OFF AND ON
FAN FILTER LIGHT IS ON
FAN DOES NOT OPERATE
WHEN FAN ON/OFF
BUTTON IS PRESSED OR
WHEN + OR – BUTTON
IS PRESSED
LOUD OR ABNORMAL
AIRFLOW NOISE
FAN FAILS TO CIRCULATE
AIR OR MOVES AIR
SLOWER THAN NORMAL
LOUD OR ABNORMAL
AIRFLOW NOISE
THE HOOD CONTROLS
ARE NOT OPERATING
CORRECTLY
EARLY BULB FAILURE
POSSIBLE CAUSE
reset circuit breaker.
be harmful to the motor. Check to be sure the filter is clean. If off
and on cycling continues, call for service. Visit GEAppliances.com for
available makeup air solutions.
metal grease filters. The light will glow until the filters are replaced.
filter in place.
Disconnect power to the unit. Lift the lower duct cover and look at the
blower connector plug. If the blower connector plug is loose, plug it in
securely. See the Installation Instructions for the plug location and how
to plug in the connector.
and a maximum duct length of 100 equivalent feet to perform optimally.
Using smaller duct pipe or longer equivalent lengths of duct pipe will
cause improper venting. GE service technicians cannot correct this issue
if installed improperly.
sure your wall or roof cap has a blade or door.
swings freely. Damper blades may flip over and will not fully open when
this happens. Adjust to original position.
the metal grease filter and replace charcoal filter (if present). See Care
and Cleaning.
appliances to operate to rating. Check with local building codes, which
may require or strongly advise the use of makeup air.
the circuit breaker. Wait 30 seconds to allow controls to reset.
to keep skin oils off bulbs.
The Problem Solver
Stainless Steel Hood
" ducting
7