Tabla de contenido
Publicidad
OP5
(1)
OP6
28
English
8. Operation
■ STOPPING ENGINE
1. Release the throttle lever and run the engine for a
half minute.
2. Shift the ignition switch to the STOP position.
NOTE
• Except for an emergency, avoid stopping the engine
while pulling the throttle lever.
■ ADJUSTING IDLING SPEED (OP5)
1. When the engine tends stop frequently at idling
mode, turn the adjusting screw clockwise.
2. When the cutting head keeps rotating after releasing
the trigger, turn the adjusting screw counter-
clockwise.
(1) Idle adjustment screw
NOTE
• Warm up the engine before adjusting the idling
speed.
■ LINE HEAD USAGE
WARNING
1. Always wear eye protection such as safety
goggles. Never lean over the rotating cutting
head. Rocks or other debris could be thrown into
eyes and face and cause serious personal injury.
2. Keep the debris guard attached in place at all
times when the unit is operated.
TRIMMING GRASS AND WEEDS
• Always remember that the TIP of the line does
cutting. You will achieve better results by not
crowding the line into the cutting area. Allow the unit
to trim at its own pace.
1. Hold the unit so the head is off the ground and is
tilted about 20 degrees toward the sweep direction.
(OP6)
2. You can avoid thrown debris by sweeping from your
right to the left.
3. Use a slow, deliberate action to cut heavy growth.
The rate of cutting motion will depend on the
material being cut. Heavy growth will require slower
action than will light growth.
4. Never swing the unit so hard as you are in danger of
losing your balance or control of the unit.
5. Try to control the cutting motion with the hip rather
Publicidad
Tabla de contenido
