Using The Machine - GGP ITALY SPA B 26 J Manual De Instrucciones

5.2 THROTTLE CONTROL LEVER
Enables the speed of the cutting means
to be adjusted (fig. 10.B; fig. 11.B).
The throttle control lever (fig. 10.B; fig. 11.B)
can be used only if the throttle safety lever is
pushed at the same time (fig. 10.C; fig. 11.C).
The correct running speed will be achieved
by pressing the throttle control lever (fig.
10.B; fig. 11.B) as far as possible.
5.3 THROTTLE SAFETY LEVER
The throttle safety lever (fig. 10.C;
fig. 11.C) enables the throttle control
lever (fig. 10.B; fig. 11.B).
5.4 THROTTLE SHUTTER
BUTTON (OPTIONAL)
Used to turn on the engine
when cold (fig. 10.D).
5.5 HANDLE FOR MANUAL START
Enables manual starting of the
engine (fig. 10.I; fig. 11.I).
5.6 CHOKE LEVER (STARTER)
Used to turn on the engine when cold. The
starter has two positions (fig. 10.E; fig. 11.E):
position B - the starter is
engaged (for cold start)
position A - the starter is not
engaged (normal warm start)
5.7 PRIMER CONTROL BUTTON
Press the rubber button of the primer
to inject fuel into the carburettor intake
manifold to facilitate startup when the
engine is cold (fig. 10.F; fig. 11.F).

6. USING THE MACHINE

IMPORTANT The safety regulations to
follow during machine use are described
in Chapter 2. Strictly comply with these
instructions to avoid serious risks or hazards.
IMPORTANT The machine
is supplied without fuel.
6.1 PREPARATION
Before using the machine:
1. check that there is fuel For preparing
the mixture, methods and refuelling
precautionsent(see paragraph 7.2
and paragraph 7.3).
2. wear the harness correctly
(see paragraph 6.1.1).
6.1.1 Using harnesses
The harness must be put on before
connecting the machine to the special
coupling and the belts must be adjusted
to suit the operator's height and build.
Always use a harness that is suited
to the weight of the machine:
- for machines weighing less than 7.5 kg,
single or double belt models can be used;
- the double belt model must be used for
machines weighing more than 7.5 kg.
• Models with single belt
The belt (fig. 10.A) must go from the
left shoulder to the right hip.
• Models with double belt
The belt (fig. 9B) must be worn with:
– the machine's support and snap-hook
coupling on the right side (fig. 9.B.1);
– the quick release in front (fig. 9.B.2);
– the belts cross-over on the
operator's back (fig. 9.B.3);
– the buckle properly fastened on
the left side (fig. 9.B.4).
The belts must be tensioned so that the load
is evenly distributed on the shoulders.
6.2 SAFETY CHECKS
Run the following safety checks and
check that the results correspond to
those outlined on the tables.
Always carry out the
safety checks before use.
EN - 8