Assembling Procedures - Tanaka TLE-550/600 Manual Del Propietário

En 4. AFTER OPERATION
a. Stop engine and drain fuel before inspecting or maintaining unit.
b. Clean unit thoroughly, removing all dust that may have collected.
c. Store unit in a cool and dry place.
d. CAUTION : CUTTING BLADE CONTINUES TO TURN FOR A SHORT TIME AFTER THE
ENGINE HAS BEEN STOPPED. MAKE SURE THAT THE BLADE IS DISENGAGED AND
HAS STOPPED COMPLETELY BEFORE ADJUSTING OR MAINTAINING THE UNIT.

ASSEMBLING PROCEDURES

1. HANDLE ASSEMBLY
a. Install the right handle onto the brackets which sre attached to the left handle using 2 pcs. 6
35 bolts, 2 pcs. 6 mm nuts and 2 pcs.6 mm washers. (Fig. 1)
b. Install handle A onto handle holders A and B by using 2 pcs. 8
washers. Bend the lock washers against the bolt head after tightening. Next secure handle
A with the locking knobs, 2 pcs. 8 mm washers and 2 pcs. 8 mm spring washers. (Fig. 2)
c. Install the assembled upper handle with 4 pcs. 6
pcs. 6 mm nuts. (Fig. 3)
NOTE: Handle height can be changed by loosening and tightening locking knobs.
2. WHEEL INSTALLATION
a. To install the front wheel, first remove the front wheel shaft. Then while holding the wheel in
place, re-install the front shaft using wheel spacers on both sides. Secure with 8 mm nut, 8
mm washer and 8 mm spring washer. (Fig. 4)
b. To install rear wheels, temporarily remove the nuts, spring washers and washers from the
rear axle. Install the rear wheels and secure them with the washers and nuts in the same
order. (Fig. 5)
Fig. 1
Fig. 3
8
18 bolts, 4 pcs. 6 mm washers and 4
Fig. 4
20 bolts and 2 pcs. lok
Fig. 2