König Electronic KN-WS600 Manual De Uso página 5

(3) Assign channel 2 or 3 to the remote sensor by setting the slide switch inside the battery compartment.
(Channel 1 is used by the anemometer and should not be assigned to the new remote
thermo-hygrometer).
(4) Press the "Tx" button inside the battery compartment of the remote sensor to transmit temperature and
humidity data to the monitor. Then close the battery door and tighten the screws.
(5) Hold the "CHANNEL/SEARCH" button on the monitor to search for all remote sensors. The temperature
and humidity readings of your selected channel number will be displayed on the monitor if RF
transmission is successful.
OPERATION
Names and functions of buttons:
RAIN/CLEAR Read daily/monthly/weekly/total rainfall
RAIN HISTORY Read current and past 6 days, weeks or months rainfall data
WIND Read average and gust wind speed
WIND ALARM Read high gust wind alarm and low wind chill alarm
PRESSURE Toggle pressure unit among hPa, inHg and mb
CHANNEL/SEARCH Select indoor, Channel 1, 2, 3 or auto scroll
MEMORY Read maximum/minimum records
HEAT INDEX/
Read heat index and dew point
DEW POINT
CLOCK Read time, calendar and day of week
ALARM Read alarm time; enable/disable alarm
▲ UP 1 Step forward in setting
▼ Down 1 Step backward in setting
SNOOZE/LIGHT Trigger snooze alarm and extend backlight
WIND ALARM Enable/disable high gust wind alarm and low wind chill alarm
Toggle wind speed unit among Beaufort, mph, m/s, km/h and
WIND UNIT
knot
RAIN UNIT Toggle between mm and inch rainfall unit
Search for radio-controlled time
ZONE Toggle RC time and zone time
°C/°F Toggle degree unit between °C and °F
CONNECTING WITH REMOTE SENSORS
The weather station uses 433 MHz radio signals to send and receive weather data between the monitors and
remote sensors.
After battery/adapter installation, the monitor will automatically search for remote sensors.
You can also enforce a searching mode by holding "CHANNEL/SEARCH" on the monitor.
Follow the instructions in the "INSTALLATION" section to set up the sensors and wireless connection. If the
connection cannot be established, reset the remote sensor by removing the batteries from the sensor. Wait for
10 seconds and reinstall the batteries. Then hold "CHANNEL/SEARCH" on the monitor to search for the
sensors. If that continues to fail, shorten the distance between the sensor and monitor and reinstall the
sensors if necessary (for details, refer to the "INSTALLATION" section).
Anemometer (with built-in temperature and humidity sensor):
Important: Wind direction calibration is needed whenever the anemometer is reset (or during battery
replacement).
Searching mode display:
Wind direction, temperature and humidity information will flash.
RF Connection completed:
Valid wind speed/direction and Ch-1 temperature/humidity readings appear.
(It may take up to 10 minutes to receive all wind speed/direction and Ch-1 temperature/humidity readings
during the searching mode).
Press Functions
5
Hold 3 seconds
Clear rainfall record
Enter high wind speed alarm and low
wind chill alarm setting
Sea level pressure setting
Search for all remote sensors
Clear memory record
Set clock and calendar
Alarm time setting
Fast advance
Fast backward
Zone time setting