König Electronic KN-WS600 Manual De Uso página 6

RF Connection failed:
"- - - -" wind speed appears; no wind direction. Unable to display Ch-1 temperature and humidity.
Rain Gauge:
Searching mode display:
Total rainfall information will flash.
RF connection completed:
Valid total rainfall reading appears.
RF connection failed:
"- - - -" stops flashing and stays on the total rainfall display (previous daily/weekly/monthly rainfall readings
remain on record).
Important: Select Ch-2 or 3 for additional remote thermo-hygrometer sensors since Ch-1 has been assigned
to the anemometer.
Searching mode display:
Temperature and humidity information will flash.
RF Connection completed:
Valid temperature/humidity readings of your selected channel appear.
RF Connection failed:
Unable to display the temperature and humidity readings of your selected channel.
WEATHER FORECAST AND BAROMETRIC PRESSURE
The unit predicts the weather conditions of the next 12 – 24 hours based on the change of atmospheric
pressure. The coverage area is around 30 – 50 km. The weather forecast is based on atmospheric pressure
change and is about 70 – 75% accurate. As weather conditions cannot be 100% accurately forecasted, we
cannot be responsible for any loss caused by an incorrect forecast.
SUNNY PARTLY CLOUDY CLOUDY RAINY STORMY
To obtain an accurate weather forecast and barometric pressure reading, you need to input your current local
sea level pressure. After battery/adapter installation, it will enter directly into sea level pressure setting mode and
the pressure reading will flash. Press "▲" or "▼" to set the value and press "PRESSURE" to confirm and exit.
You can also hold the "PRESSURE" button to enter the sea level pressure setting in normal display mode.
Press "▲" or "▼" to set the value and press "PRESSURE" to confirm and exit.
Press the PRESSURE button to select the pressure unit among hPa, inHg and mb.
Note: You may obtain your current local sea level pressure information from the weather website.
IN/OUT TEMPERATURE AND HUMIDITY
Temperature and humidity readings are shown on the upper right of the display.
Press the "°C/°F" button to select a temperature unit from °C or °F.
Press "CHANNEL/SEARCH" repeatedly to select indoor, Ch1, Ch2, Ch3 or auto-channel scrolling display
modes.
Note: The outdoor temperature and humidity sensor is built inside the anemometer and is assigned to
channel 1. Additional remote thermo-hygrometer sensor(s) can be purchased separately and they should be
assigned to Ch2 or 3 only.
ICE ALERT
The ice alert indicator appears on the display next to the wind chill reading when the outdoor channel-1
temperature falls to or below 4°C (or 39.2°F). It provides an early alert for possible icy road conditions to the
driver.
IN/OUT HEAT INDEX
The Heat Index combines the effects of heat and humidity. It is the apparent temperature of how hot the
heat-humidity combination makes it feel.
Press the "Heat Index/Dew Point" button once to show the respective indoor or outdoor heat index on the
display. The "HEAT INDEX" icon will appear.
IN/OUT DEW POINT
The dew point is the saturation point of the air, or the temperature to which the air has to be cooled in order to
get condensation.
Press the HEAT INDEX / DEW POINT button twice to show the respective indoor or outdoor dew point
reading on the display. The "DEW POINT" icon will appear.
6