Skil PWR CORE 12 Manual Del Propietário página 12

Direction-of-Rotation (Forward/Center-Lock/Reverse) Selector
WARNING
injury .
Your tool is equipped with a direction-of-rotation selector located above the trigger switch. This
selector is designed for changing the direction of rotation of the bit and for locking the trigger
in the "OFF" (center-lock) position.
a. Position the direction-of-rotation selector to the far left of the tool for forward rotation.
b. Position the direction-of-rotation selector to the far right of the tool for reverse rotation.
c. Setting the switch in "OFF" (center-lock) position helps to reduce the possibility of accidental
starting when not in use (Fig. 3).
NOTICE: To prevent gear damage, always allow the impact wrench to come to a complete
stop before changing the direction of rotation.
NOTICE: The impact wrench will not run unless the direction-of-rotation selector is engaged
fully to the left or right.
Fig. 3
Center-Lock
Variable-Speed Trigger Switch
Your tool is equipped with a variable-speed
trigger switch. The tool can be turned "ON" or
"OFF" by depressing or releasing the trigger.
The variable-speed trigger switch delivers high-
er speed with increased trigger pressure and
lower speed with decreased trigger pressure
(Fig. 4).
12
After tool use, lock the direction-of-rotation selector in the
"OFF"position (center-lock) to help prevent accidental starts and
Forward
Fig. 4
Variable-speed
Trigger Switch
Reverse