Charging Batteries - Topcom 7000 Manual De Usuario

before you can reply to the message. At the end of each transmission the unit will send a
beep. To reply, just press the
If 2 or more users press the
receiver will receive only the stongest signal and the other signal
(s) will be supressed. Therefore you should only transmit a
signal (press
8

Charging batteries

For safety reasons, only use the power adapter plug supplied (KEAD-237
(DVE DV-6400UP) for two units charging / KEAD-244 (DVE DV-6200UP)
for one unit charging only).
Your radio will not Transmit / Receive during charging.
Set the main switch (6), located on the bottom of the walkie-talkies to ON.
8.1 Desktop charger
The TT7000 is internally equipped with a build in Li-ion battery (3.7 V Li-ion Battery, 700 mAh).
The high quality battery has a minimum of 300 charging cycles (empty to fully charged).
The battery can only be replaced by a Topcom service center. The replacement of the battery
is excluded from the warranty.
1. Put the desktop charger on a flat surface.
2. Plug one end of the supplied adapter into the
electric socket and the other two ends into the
connectors on the backside of the desktop charger
as illustrated in the diagram.
3. Set the main switch (6), located on the bottom of
the walkie-talkies to ON.
4. Put the radios in the charger as indicated.
5. The charging LED will turn on if it's properly
inserted and charging.
It will take about 18 hours to fully charge the batteries. Make sure that the unit have been
charged for that period the first time.
8.2 Plug in charger
Instead of using the desktop charger you can connect the
power adapter plug of the power adapter directly to the
headset/charging socket on top of the walkie talkies.
Topcom Twintalker 7000
-button and speak into the microphone.
PTT
- button at the same time the
PTT
- button) when the channel is free.
PTT
Topcom Twintalker 7000
OFF ON
OFF ON
5