Innenseiten.qxd
● Some types of unit are equipped
with a connection for an air com-
pressor. The following must be ob-
served in such a case.
- Compressor boost pressure or
compressed air supply max. 6 bar.
- Ensure the pump is in the locked
position before pressurizing.
- The non-return valve in the com-
pressor connection must not be re-
moved to depressurize the tank.
Spraying
● To start the spraying process push
the operating lever on the quick
close valve down. Releasing the op-
erating lever will stop the spraying
process immediately.
● The optimum spray pressure for the
best distribution of the liquid being
sprayed is 2-6 bar.
Emptying and
Servicing
● Operate the pressure relief valve
(red button) until the unit is no longer
under pressure.
● Open the pump carefully, at first only
a few turns to the left, to allow any
compressed air still in the tank to
escape. Only then should the pump
04.05.2006
17:01 Uhr
● Clean the unit thoroughly with water
● Store the unit in a depressurised
● Filter tube: unscrew the quick-con-
● The service life of the unit will be
● Protect the unit against frost.
● It is forbidden to make changes to
● To obtain optimum cleaning of the
● Important note: Undue strain
15
Seite 15
be unscrewed completely and re-
moved from the tank.
after each use, rinsing out several
times, and leave open to dry, if pos-
sible hanging up with the opening
pointing down.
condition.
nection valve at the handle. Caution!
Ensure the unit has been depressur-
ized first.
greatly extended by occasionally ap-
plying resin and acid-free grease to
the sealing ring between the pump
and the tank and to the inner O ring.
the tank (welding, brazing, etc.).
spray unit and to ensure that spray
compound residues are neutralised,
we recommend the use of GLORIA
Special Activated Charcoal, Art. No.
263.0000.
caused by the mode of operation
(including transport to site where
used and storage when not in use),
environmental influences (at the site
GB