Sears Kenmore 10655244400 Manual De Uso Y Cuidado página 7

Refrigerador de dos puertas
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Handle Removal
(optional)
1. Apply firm pressure with your hand on the face of trim. Slide
Lop trim up and boftom trim down away from handte. Lift trim
pieces off shoulder screws. See Graphic t.
2.
Remove handle screws and handles. See Graphic 1.
3.
Move refrigerator into place. Replace handtes as shown. See
Graphic t.
Door Removal
Electrical Shock Hazard
Disconnect power before removing doors,
Failure to do so can result in death or etectrical shock,
1.
Unplug refrigerator or disconnect
power.
2. Open both refrigerator doors. Remove the base grille by
pulling up on the bottom outside corners. See Graphic 2.
3. Close both doors and keep them ctosed until you are ready to
lift them free from the cabinet.
4.
If you have a dispenser (ice or water), disconnect
the water
dispenser tubing located behind the base gritte on the freezer
door side. See Graphic 3.
Press the red outer ring against the face of the fitting and
pult the dispenser tubing free.
On some modeis, remove the tubing from hose clip.
5.
Remove the top teft hinge cover and screws as shown. See
Graphic 4. Do not remove screw A.
6.
Disconnect wiring:
Disconnect wiring plug.
Remove green ground wire screw to disconnect
ground
wires.
C
8.
Remove the top right hinge cover and screws as shown. See
Graphic 6. Do not remove screw 1.
9.
Lift the refrigerator door straight up and off of the boftom
hinge.
10. It may not be necessary to remove the bottom hinge to move
the refrigerator through a doorway. Both bottom hinges have
simitar construction.
Remove the hinges as shown. See Graphic 7. Do not
remove screw A.
Door and Hinge Replacement
1.
Replace both boftom hinges, if removed. Tighten screws.
2. Carefully feed the dispenser tubing threugh the bottom left
hinge before replacing the freezer door on the hinge.
Assistance may be needed.
NOTE: Provide additionai support for the doors while the top
hinges are being replaced. Do not depend on the door magnets
to hoid the doors in place while you are working.
3.
Reconnect water dispenser tubing by pushing tubing into
rifting until it stops and black mark touches face of fitting. See
Graphic 3. On some modets, replace tubing in hose clip.
4. Atign and reptace the top left hinge as shown. See Graphic 4.
Tighten screws.
Electrical Shock Hazard
Reconnect both ground wires.
Failure to do so can result in death or electrical shock.
Reconnect both ground wires.
Reconnect wiring plug.
C
F
A
B.S
A. Do not remove screw A
B. Ground wires
C. Green ground wire screw
D. Wiring ptug
7. Carefully lift freezer door straight up and off of the bottom
hinge. See Graphic 5. The water dispenser tubing remains
attached to the freezer door and pulis through the bottom ieft
hinge. Make sure you protect the dispenser tubing from
damage.
A. Do not remove screw A
B. Ground wires
C. Green ground wire screw
D. Wiring pfug
5.
Reptace left hinge cover and screws.
6.
Reptace the refrigerator door by carefully lifting the door onto
the bottom right hinge.
7. Align and replace the top right hinge as shown. See
Graphic 6. Tighten screws.
8.
Replace hinge cover and screws. Tighten screws.
9.
Plug in refrigerator or reconnect power.

Publicidad

Tabla de contenido
loading

Tabla de contenido