Manual Search - Oki V40A-PHS Instrucciones De Manejo

Do you want to search for
analogue channels?
Yes
Highlight "Yes" and press "SELECT" button to searh
for analogue channels.The following menu appears
on the screen for analogue channel search.
Auto Program
Country
Language
TXT Language
PLEASE CHECK ANTENNA CABLE
AUTO. PROGRAMMING SYSTEM
English
By pressing " " or " " button, adjust the Country
item and press " " to highlight "Language" item.
Use " " or " " button to set "Language". Use " "
or " " buttons to select "TXT Language" and set it
by using " " or " " buttons. Press "OK" button to
continue:
APS is running...
UK
P 03 - C 04
After APS is finalized, the programme table will ap-
pear on the screen. In the programme table you will
see the programme numbers and names assigned to
the programmes.
If you do not accept the locations and / or the
programme names, you can change them in aps sub-
menu in the settings menu.
No
Ok
Cancel
63.75 MHz
6%
63.75 MHz
Cancel
English - 39 -
All the services are searched and a channel table is
created automatically.
All channels found are stored in a sorted form with
respect to their channel numbers. Some services may
not appear with the correct channel number. At the
time of printing, not all broadcasters are sending their
channel number information.

Manual Search:

In Manual Search, the number of the multiplex is
entered manually and only that multiplex is searched
for the channels. For every valid channel number,
signal level, signal quality and network name are
shown at the bottom of the screen.
In both manual and auto search any existing channel
in the database is not re-stored to avoid redundant
duplicates of that channel.
First Time Installation
The user can use this item to load default settings,
which had been loaded to the receiver at the factory.
To install factory settings, highlight "First Time In-
stallation" menu item and press "SELECT" button,
then you will be asked to tings. Selecting "Yes" by
pressing "SELECT" button while the "Yes" is high-
lighted and then the existing channel table will be de-
leted.
Are you sure you want to delete all channels and
settings for first time installation?
Yes
After factory settings is loaded, "First Time Instal-
lation" menu will be displayed.
The menu which is displayed for language selection
appears on the screen at first. By using
buttons, select the desired language option, and press
"SELECT" button to activate.
After the language is selected, a message asking for
automatic search start appears on the screen.
Do you want to start automatic search?
Yes
Highlight "Yes" item by pressing
press "SELECT" button to start installation. After search
is completed for digital channels, a message asking
search for analogue channels appears on the screen.
Do you want to search for
analogue channels?
Yes
Highlight "Yes" item by pressing
press "SELECT" button to searh for analogue
No
or
No
or buttons and
No
or buttons and