U.S. MODELS:
IMPORTANT
- All U.S. models are designed
for a 3-WIRE SYSTEM
CONNECTION.
The dryer frame is
grounded
to the neutral conductor
at the terminal
block. A 4-WIRE SYSTEM
CONNECTION
is required for
new or remodeled
construction,
mobile homes,
or if local codes do not permit grounding
through
neutral.
If you use the 4-wire system,
you cannot
ground the dryer frame to the neutral conductor
at the terminal
block.
Refer to the following
instructions
for 3- and 4-WIRE SYSTEM
CONNECTIONS:
Remove the terminal
block cover plate. Insert the power cord with a UL-listed
strain relief through
the hole
provided
in the cabinet
near the terminal
block.
A strain relief must be used. Do not loosen the nuts already installed on the terminal
block.
Be sure they are
tight. Use a 3/8" (1 cm) deep well socket.
9.
To ensure that the dryer provides
optimal drying performance,
it must
be level. To level the dryer, follow the lettered steps below:
Level
ao
Using a level, check if the dryer is level side to side and then front
to back.
bo
If the dryer is not level, adjust the leveling feet on the bottom
of
the dryer until the dryer is level side to side and back to front.
Turning the feet clockwise
retracts the feet. Turning the feet
clockwise
loosens and extends them.
[_
To set the dryer to the same height as the washer, fully
retract the leveling feet by turning them counterclockwise,
then loosen the feet by turning them clockwise.
Once
the dryer is the same height as the washer, follow the
directions
above to level the dryer.
Leveling
feet
Retract fully
Then loosen
L
[_
djust the leveling feet only as much as necessary
to level the dryer. Extending
the leveling
feet more than necessary
can cause the dryer to vibrate.
10. Make sure all gas connections
(on gas models),
exhaust,
and electrical
connections
are complete.
Plug
in your dryer, and then check
its operation
by using the checklist
below.
1 t. For GAS MODELS
ONLY
The burner may not ignite initially due to air in the gas line. Allowing
your dryer to operate
on a heat
setting will purge the line. If the gas does not ignite within 5 minutes,
turn your dryer off and wait 5
minutes.
Be sure the gas supply to your dryer has been turned on. To confirm
gas ignition, check the
exhaust for heat.
FINAL INSTALLATION
CHECKLIST
[]
The dryer is plugged
into an electrical
outlet and is properly
grounded.
[]
The exhaust
ductwork
is hooked
up and joints are taped.
[]
You have used rigid or stiff-walled
flexible
metal duct material, not plastic flexible duct.
[]
The dryer is leveled and is sitting firmly on the floor.
[]
For gas models:
The gas is turned on and there are no gas leaks.
[]
Start your dryer to confirm that it runs, heats, and shuts off.
English o 17
D_736J4000E((
) 030641)
0OEN1S0416indd
Secll:17