Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
CONNECTING
THE INLET HOSE
Method 1 - Using the Y Connector
and Long Hose
The dryer must be connected
to the cold water faucet using new inlet hoses. Do not use old
hoses.
t.
Turn off the cold water faucet.
2.
If you have a washer water hose attached
to the cold water
faucet, unscrew
and remove the hose.
3.
If space permits,
attach the brass female end of the
"Y"connector
to the cold water faucet. Turn by hand until
tight.
4.
Attach the straight
end of the long hose to the "Y'
connector.
Screw
on the hose coupling
by hand until it is
tight.
5.
Using pliers, tighten the hose coupling
with an additional
two thirds turn.
[_Do
overtighten,
can damage
coupling.
not
You
the
6.
Attach the angled end of the long hose to the fill valve at
the bottom
of the dryer's rear frame. Screw
on the coupling
by hand until it is tight.
7.
Using pliers, tighten the hose coupling
with an additional
two thirds turn.
[_}
Do not overtighten,
can damage
coupling.
You
the
_q_"_lL Duct Exhaust'
/
8.
Attach the water
hose to the other side of the "Y" connector.
Screw
on the hose coupling
until it is tight. Using pliers, tighten the coupling
with an additional
two thirds turn.
_Do
not overtighten.
You can damage
the coupling.
9.
Turn the water faucet on.
t0. Check for leaks around the "Y" connector,
faucets,
and hoses.
English o 20
DV3614000E((
) 030641)
00
EN
150416illdd
Secll:20
Publicidad
Tabla de contenido
