Installing The Monitor; Fix The Monitor - Extel WEVP 626 E BIS Instrucciones De Uso E Instalación

3. INSTALLATION
Important: if you try the system before installing it, make sure the street unit and the monitor are not in the
same room, otherwise the videophone will emit piercing feedback noise.
2
4
3
a. Installing the roadside panel (camera)
1. Fit the plastic box taking
2. Remove the 2 screw caps
3. Connect the link wire according to the wiring diagram.
4. Fix the board on the built-in box sing the two screw
5. Replace the 2 screw caps.
Do not expose the camera to direct sun light or to reflective surface.
Put a silicon gasket on the upper half between the external panel and the wall
b. Installing the monitor
1. Fix the wall support (2).
2. Connect the wires from the roadside
panel and from the lighting system.
3. Connect the adapter plug
monitor (without connecting it to mains
outlet)

4. Fix the monitor

port (2) .
2
5. After being sure the installation is
completed, connect the adapter power
supply plug to mains outlet.
Note: if the power supply cord is cut, respect polarity
5
3
6
2
care not to block the attachment nuts of the panel.
1
with a small screwdriver to put in the slot (5).
2
2
(3) to the
3
(1) on the wall sup-
1
1
supplied ; do not forget the waterproof gasket
4
3
22GB
4
3
2
1
6
6 .
.
5