02Centrixx_Retro_gb.book Seite 27 Freitag, 16. Mai 2008 12:40 12
3 Operating
2
3
Operating
3.1 Cleaning
WARNING:
Only assemble the accessory if the plug has been
removed from the socket.
During use, the accessory becomes very hot. Therefore
wait until the accessory has cooled down before
changing it. There is a danger of scalding.
Proceed as follows to attach the nozzles:
1. Switch the appliance off and pull the plug out of the
socket.
2. Wait until the accessory just used has cooled down.
1
3. Press the release button (Fig. 7/1) and remove the
accessory just used.
4. Push on the desired number of extension tubes.
3
5. Now push on the desired accessory.
2
NOTE:
Fig. 7
To use one of the round brushes (Fig. 7/2), push it onto
the jet nozzle (Fig. 7/3).
6. Secure the accessory no longer required in the
accessories mount, as far as this is possible. Keep the
other accessories safe and inaccessible to children.
Hot steam can make it easier to remove dirt from smooth
surfaces such as work surfaces, cooking containers, and
floor or wall tiles. Use the steam cleaner to loosen and
remove accumulated foodstuffs, grease, mould, as well as
loose and ground-in dirt, or to freshen up textiles. The
steam cleaner works entirely without chemical solvents.
WARNING:
Check the steam cleaner and the power cable before
each use. A damaged appliance must never be used.
There is a risk of injury.
ATTENTION:
Only use the steam cleaner if the water tank is inserted
correctly. Non-compliance can damage the steam
cleaner.
27