02Centrixx_Retro_gb.book Seite 33 Freitag, 16. Mai 2008 12:40 12
5 Correcting malfunctions
5
Correcting malfunctions
Before sending the appliance to Royal
check whether you can correct the malfunctions yourself.
WARNING:
Before starting to troubleshoot, switch the appliance off and pull out the mains plug. Wait until the
appliance and the accessory have cooled down. Never use a defective appliance.
Malfunction
Possible cause
The status light is
Plug is not plugged in or the
not illuminated.
appliance is not switched on.
Socket does not carry any
current.
Power cable is damaged.
The appliance
No water in tank.
does not produce
any steam.
Appliance is not yet ready to
operate.
Nozzle is blocked.
6
Cleaning
6.1 Cleaning the housing
®
Appliance Customer Services, use the following table to
Solution
Plug in plug and switch on appliance,
Chapter 3.1, "Cleaning".
Test the steam cleaner at another socket
which you are sure carries current.
Have the cable replaced by Royal
Appliance Customer Services, address,
Page 35, "Warranty".
Refill with water
Wait approx. 30 seconds until the appliance
has heated up
Contact Royal
services, address,
WARNING:
Before you clean the appliance, switch off the appliance
and remove the mains plug. Wait until the appliance and
the accessory have cooled down.
Only clean the housing with a slightly damp cloth. Do not
use any cleaning agent, scouring agent or alcohol as these
can damage the housing.
®
Chapter 3.1, "Cleaning".
Chapter 3.1, "Cleaning".
®
Appliance customer
Page 35, "Warranty".
33