Tabla de contenido
Publicidad
troubleshooting
If one or more functions on the bed base have stopped operating:
•
Check under the bed base to verify that the wired connections are secure and that there are no cords or bedding obstructing the
movement of the base .
•
Check to ensure the green LED light is illuminated on the control box . If there is no light, verify that the input and power cords are
properly connected .
•
Unplug the base for 1 hour to reset the electronic components .
•
Plug bed base into a different electrical outlet, or test current outlet with another working appliance (a grounded, electrical surge
protector is recommended) .
•
Install new batteries in the remote control .
•
Remove and replace full batteries in the remote control and re-pair the remote to the base (see page 16)
If issue is not resolved by following the instructions above, locate serial number on warranty card, manual or back of remote and call
Ergomotion Customer Service: US 1-888-550-3746
19
Publicidad
Tabla de contenido
