Yamaha HTR-5066 Guía De Configuración Sencilla página 8

• If the cursor keys do not work, press SOURCE/RECEIVER (to
light up the key in orange) and then use the cursor keys.
• If any error message (such as E-1) or warning message (such
as W-2) appears, see "Error messages" or "Warning
messages" in "Owner's Manual".
• If the warning message "W-1:Out of Phase" appears, see "If
"W-1:Out of Phase" appears".
3
Use the cursor keys (e/r) to select
"SAVE" (Save) and press ENTER.
A u t o S e t u p
M e a s u r e m e n t
F i n i s h e d
S t a r t
Result
E x i t S A V E
3 / 2 / 0.1 ch
3.0 / 10.5 m
3.0 / +10.0 dB
>Save Cancel
4
Disconnect the YPAO microphone from the
unit.
This completes optimization of the speaker settings.
• The YPAO microphone is sensitive to heat, so should not be
placed anywhere where it could be exposed to direct sunlight or
high temperatures (such as on top of AV equipment).
If "W-1:Out of Phase" appears
Follow the procedure below to check the speaker
connections.
A u t o S e t u p
S t a r t
E x i t
a Check for the blinking of the front display's indicator to
identify the problem speaker.
W-1:PHASE
VOL
b Check the cable connections (+/-) of the problem
SW
C speaker.
L R
SL SR
If the speaker is connected correctly:
Depending on the type of speakers or room
environment, this message may appear even if the
speakers are connected correctly.
Proceed to step 3.
If the speaker is connected incorrectly:
Turn off the unit, reconnect the speaker cable, and then
try YPAO measurement again.
M e a s u r e m e n t
F i n i s h e d
Result
3 / 2 / 0.1 ch
3.0 / 10.5 m
3.0 / +10.0 dB
OK:ENTER
Warning
W 1:Out of Phase
message
Problem speaker (blinks)
VOL
SW
C
L R
SL SR
7
En