Esn Security Operating Procedure; About Esn; How To Operate The Esn (Key Cd) Security; How To Program The Key Cd - Eclipse CD7100 Manual Del Propietário

ESN security operating procedure

About ESN

This main unit is equipped with ESN (ECLIPSE
Security Network). A preregistered music CD
(Key CD) on which all main unit functions will not
operate, even by turning the ignition switch to the
ACC or ON position or reconnecting the battery
after turning the
disconnecting the battery during maintenance.
ESN can be set or canceled using any of the
following methods:
• Key CD security
You can record a specific CD that you have as a
"key CD" with the main unit, and this CD can then
be used to set and cancel the security settings.
How to operate the ESN (Key
CD) security

How to program the Key CD

Check that the main unit is in
1
standby.
Press and hold the button [6], then
2
[SCREEN] button, and hold both
for more than one second.
A [SEC] message appears, in two
seconds it will change to [DISC].
ATTENTION
• If a CD has already been inserted, a [SEC]
message appears, and then the front panel
opens and the CD is ejected.
• If a security is activated, programming the
Key CD is not available.
Press the
3
button.
The front panel opens; The CD7100 is
now ready for your Key CD in the CD
slot.
ignition switch off
[ (OPEN/EJECT)]

ESN security operating procedure

4 Insert the CD into the slot.
A [SEC] message appears, then the
Key CD is ejected.
Press the
5
button.
or
The front panel closes.
ATTENTION
• If there is a problem with the inserted CD,
an [ERR] message will appear for two
seconds and the CD will be ejected.
Reinsert the ejected CD.
• If a CD causes the [ERR] message to
appear twice in a row, a [CHANGE]
message will appear for two seconds. Try
another CD.
• Copy Protected CD and MP3/WMA CD-ROM
cannot be programmed for Key CD security.
• The Security indicator will flash whenever
the vehicle's ignition is switched off.

How to cancel the Key CD

Check that the main unit is in
1
standby.
Press and hold the button [6], then
2
[SCREEN] button, and hold both
for more than one second.
A [SEC] message appears, then in two
seconds it will change to [DISC].
Press the
3
button.
The front panel opens; The CD7100 is
now ready for your Key CD in the CD
slot.
[ (OPEN/EJECT)]
[ (OPEN/EJECT)]
VII
VIII
39