Machine Operation (Scrubbing And Drying) - Viper AS530R Manual De Usuario

USER MANUAL
15. Turn the key switch to "OFF"
16. Ensure the machine is stopped.

MACHINE OPERATION (SCRUBBING AND DRYING)

1. Start the machine according to procedures in previous paragraphs.
2. Start cleaning by following procedures in section of "Starting the machine".
3. If necessary, stop the machine to adjust squeegee according to section "Adjusting the balance of squeegee".
CAUTION!
To avoid any damage to the floor surface, turn off the brush/pad-holder when the machine stop in one
place.
NOTE
For correct scrubbing/drying of floors at the sides of walls, we suggest to go near the walls with right
side (Bumper wheel side) of the machine as shown in below Figure 11.
Battery charging during the work
When there is green light (A, Figure 12) on, the batteries have
enough power for the machine to work normally; when all the
green lights off, the yellow light (C, Figure 12) is on, the power
of batteries are too low, please charge the batteries; when the
red light (B, Figure 12) flashes, the batteries has run out, the
vacuum motor and brush motor will be turned off
automatically a few seconds delay, please drive the machine
for batteries charging immediately.
CAUTION!
To avoid damaging the batteries and
shortening their working life, do not use the
machine once the batteries are flat.
Figure 11
B
C
Figure 12
13
ENGLISH
A
D