Brush/Pad Cleaning - Viper AS530R Manual De Usuario

Ocultar thumbs Ver también para AS530R:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

USER MANUAL
CAUTION!
To be especial careful when battery is
charging, because there may be leaked
acid in the process of charging.
Battery acid is corrosive, if it accidentally
comes into contact with the skin or eyes,
rinse immediately with plenty of clean
water and go to see a doctor.
The preparation steps to charge the
batteries
1. Open the recovery tank cover (B, Figure 16) to check if
the recovery tank (C) is empty, or empty the recovery
tank through the drain hose (A).
2. Drive the machine to designated charging area.
3. Turn the key switch to "OFF".
4. This step only for WET batteries:
Clean the battery surface if necessary.
Check the battery electrolyte level of the
batteries (D), if necessary, open the cover to full
fill electrolyte, and then recover it.
Keep the cover opened during charging.
5. Select one of below charging mode base on the
selected charger type.
Use on-board charger for battery charging
6. Connect the battery charger cable (A, Figure 17) to the
electric mains (G), and then all machine functions
except charging are cut off automatically.
The normally on red LED (B) states that the machine is
in process of charging.
7. The batteries are fully charged when the green LED (C)
becomes on.
8. Disconnect battery charge cable from electric mains after charging is completed, and then store the battery charger
cable in the storage box (D).
NOTE
For further information about on-board charger (E, Figure 17), please refer to relevant manual from
service center.

BRUSH/PAD CLEANING

CAUTION
It is recommended to wear gloves when
cleaning the brush/pad-holder, since it may
contain sharp fragments.
1. Take the brush/pad-holder off base on procedures in
previous sections.
2. Clean the brush/pad-holder using water and detergent.
3. Check the integrity and abrasion conditions of the bristle
on the brush, if necessary, replace the brush.
4. Check the abrasion condition of the polishing pad, if
necessary, replace it.
!
E
Figure 16
Figure 17
D
C
B
A
16
ENGLISH
D
D
C
B
G
A
Figure 18
C
B
A
E

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

50000417

Tabla de contenido