USER MANUAL
USING FOR THE FIRST TIME
After nine hours using of the machine for the first time, please check if any damage or abnormal situation, check
whether the fasteners or fittings is loose.
MAINTENANCE
WARNING!
Maintenance procedures must be performed after the machine is turned off and the battery charger
cable is disconnected. In addition, carefully read the safety chapters in the manual.
All scheduled or extraordinary maintenance procedures must be performed by qualified personnel or an authorized
Service Center. This guide only describes the general and common maintenance procedures.
For other maintenance procedures that are in below maintenance schedule table, please refer to the Service Manual
that can be consulted at any Service Center.
SCHEDULED MAINTENANCE TABLE
CAUTION!
The procedure marked with (1) must be performed when the machine is used after 9 hours for the first
time.
The procedure marked with (2) must be done by Service Center that qualified by our company.
Procedure
Battery charging
Squeegee cleaning
Brush/Pad-holder cleaning
Tank cleaning
Tank sealing strip inspection
Float ball filter cleaning
Squeegee blade check and replacement
Cleaning water filter cleaning
Suction filter cleaning
WET battery fluid level check
Screw and nut tightness inspection
Brush/Pad-holder carbon brush check or replacement
Suction motor carbon brush check or replacement
Drive system motor carbon brush check or
replacement (only for machine with traction)
Add lubricating oil for rotating parts
BATTERY CHARGING
NOTE
Please charge the batteries when the yellow LED (32) or red LED (33) is on, or at the end of each working
cycle.
CAUTION
Always keep the battery in a full charged state can extend its lifetime.
CAUTION
Please charge the battery as soon as possible if the battery level is low. Otherwise, the lifespan of
battery can be reduced. It is better to check the battery at least once a week.
Daily, after
Weekly
each use
15
ENGLISH
semiannually
Yearly
(1)
(2)
(2)
(2)
(1)