Connecting A Handset Lifter To The Base Station (Optional); Adjusting The Vmx Office System To Your Fixed Line Phone - Sennheiser Communications VMX OFFICE Instrucciones De Uso

Connecting a handset lifter to
the base station (optional)
HSL 10
When connecting a Sennheiser Commu-
nications handset lifter (e.g. HSL 10,
see "Accessories" on page 21):
Connect the handset lifter to the ACC
socket ¹.
Install the microphone as described in
the handset lifter manual.
Attach the handset lifter to the
phone as described in the handset
lifter manual.
Connect the TCI 01 as described in the
TCI 01 manual.
To test the handset lifter setup:
Close and then open the microphone
boom .
The headset LED
every 5 seconds, indicating that the
headset is in standby mode.
Press the PHONE button
The connection to the headset can be
established.
Press either the hook button
PHONE button
10
¹
flashes once
·
(
or the
·
( ).
A wireless link is established between
the headset and the base station. The
handset lifter automatically lifts the
handset and the dial tone is heard in
the headset.
If no clear dial tone is heard, please
refer to "If problems occur ..." on
page 21.
Adjusting the VMX OFFICE
system to your fixed line phone
To ensure optimum intelligibility, adjust
the VMX OFFICE system to your phone as
follows:
Press the PHONE button
Wait until the PHONE LED
blue.
The headset is recognised.
Put on the headset.
Press the hook button
A wireless link is established between
the headset and the base station.
Pick up the phone handset.
Adjust the ABC switch
dial tone can be heard loud and clear
in the headset.
).
·
( ).
»
lights up
.
º
so that the
º º