BA_REFUsol 008K-023K_V04.0_WW
English
1 Safety-Related Guidelines for REFUsol
1.1 Proper usage
The REFUsol
transforms the direct current generated by the PV generator (photovoltaic modules) into alternating
current and feeds this to the public power supply network. The inverter has been constructed
according to the current state of technology and in line with the rules of technical safety. Any use
beyond this is not deemed to be proper. The manufacture will not accept liability for any damages
resulting from this and the user alone will bear all responsibility.
Note:
1.2 Introduction
To prevent personal injury and/or material damage, read the following notes before first putting the
system into operation. The safety-related guidelines must be observed at all times.
WARNING
WARNING
1.2 Qualified Personnel
The operating instructions are intended for the following persons:
Electricians who commission the device themselves and connect it to other units of the PV
system.
Service and maintenance technicians who install device expansions or carry out error analyses.
This documentation is intended for skilled specialist personnel. It is assumed that the basic
technical requirements of PV systems are known.
The device may only be installed by qualified specialists.
Copyright REFUsol GmbH
®
, referred to in these operating instructions as the inverter, is a solar inverter, which
These compact operating instructions provides all information required for
Installing, commissioning and operating the REFUsol
inverters! For further instructions on project planning and installation as well as
for additional safety-related guidelines, please refer to the detailed operating
instructions which you can find on the package CD or under www.refusol.com.
Any misuse of these devices and failure to observe the warnings
contained herein or improper interference with the safety equipment
and the device may result in material damage, personal injury, electric
shock, or even death.
Electric shock!
Do not open the device! Dangerous voltage may still be applied inside
the device even after it has been switched off.
GB
®
®
008K to 023K
21