Install The Hood - Broan B5630SS Manual De Instrucciones

BR - N
MODELS B5630SS • B5636SS • B5730SS • B5736SS
Page 4
INSTALL UPPER FLUE MOUNTING INSTALL THE HOOD
BRACKET (Horizontally Ducted Hoods Only)
Center of installation Ceiling
/
Recommended _, _'
distance between 11/8"
screw holes j
....... r---_:---_ ......
': i71/2 i
p< = _! \
i j
i i i
1.
2.
3.
4.
5.
DO NOT REMOVE the protective plastic film covering the
decorative flue and the hood at this time.
Lay the back side of the hood flat on a table. Use a piece of
cardboard to avoid damaging the table or the hood.
Attach damper / duct connector to top of hood using (4)
#8 x 3/8" Pan Head mounting screws.
Remove the grease filters by pulling down the metal latch
tab and tilting filters downward to remove.
Carefully rotate hood upright.
Center of Flush with
Ceiling • • the ceiling
\ installation
(_)
\ /
Upper flue mounting
bracket slots
1. Drill two _6" diameter holes where shown. Insert drywall
anchors into the holes.
2. Center the bracket over the hood location and flush with the
ceiling. Make sure that the slots of the upper flue bracket are
at the bottom. Secure the upper flue bracket to the wall using
(2) #8 x 1W' mounting screws.
3. Tighten the screws completely. Make sure that the bracket
is tight against the wall.
LOWER FLUE
MOUNTING BRACKET _---_ I
8W'
MAX.
t _
J
6. Make sure there will be adequate clearance between top of
hood and lower flue mounting bracket for ductwork. Elbow
must be located below lower flue mounting bracket.
7. Align the hood and center it above the hood mounting
bracket. Gently lower the hood until it securely engages the
bracket.
i
i
I
i
I
i
I
SIDE VIEW ;
INSIDE BACK
OF THE HOOD
MOTOR/BLOWER
ASSEMBLY
/
HOLES LOCATION
8. With the hood hanging in place, drill through the both holes
located in the inside lower back of hood using a 5/16" drill
bit. Insert the included drywall anchors into the drilled holes
(one for each hole). Install (2) washers and (2) no. 8 x 1W'
mounting screws through the back of the hood and into the
drywall anchors. Verify that the hood is centered and leveled.
Tighten all screws completely.
9. Reinstall grease filters by aligning rear filter tabs with slots
in the hood. pull down the metal latch tab, push filter into
position and release. Make sure filters are securely engaged
after installation.