Troubleshooting - Craftsman CMCHT98022 Manual De Instrucciones

ACCESSORIES
WARNING:
DO NOT USE THE HEDGE TRIMMER WITH ANY TYPE OF ACCESSORY OR ATTACHMENT. SUCH
USAGE MIGHT BE HAZARDOUS.
The RBRC® Seal
The RBRC® (Rechargeable Battery Recycling Corporation) Seal on the nickel cadmium, nickel metal hydride
or lithium-ion batteries (or battery packs) indicates that the costs to recycle these batteries (or battery packs)
at the end of their useful life have already been paid by Craftsman. In some areas, it is illegal to place spent
nickel cadmium, nickel metal hydride or lithium-ion batteries in the trash or municipal solid waste stream
and the Call 2 Recycle® program provides an environmentally conscious alternative.
Call 2 Recycle, Inc., in cooperation with Craftsman and other battery users, has established the program in the United States
and Canada to facilitate the collection of spent nickel cadmium, nickel metal hydride or lithium-ion batteries. Help protect
our environment and conserve natural resources by returning the spent nickel cadmium, nickel metal hydride or lithium-ion
batteries to an authorized service center or to your local retailer for recycling. You may also contact your local recycling center
for information on where to drop off the spent battery. RBRC® is a registered trademark of Call 2 Recycle, Inc.
For assistance with your product, visit our website www.craftsman.com for the location of the service center nearest
you or call the Craftsman helpline at: 888-331-4569.
Problem
Slow running, noisy or
hot blades.
Unit will not start.
Battery won't charge.

TROUBLESHOOTING

Possible Cause
• Dry, corroded blades.
• Blades or blade support bent.
• Bent or damaged teeth.
• Loose blade bolts.
• Battery not installed properly.
• Battery not charged.
• Lock off not fully operated.
• Battery not inserted into charger.
• Charger not plugged in.
• Surrounding air temperature too hot or
too cold.
Imported by
701 East Joppa Rd.
Towson, MD 21286 U.S.A.
Possible Solution
• Lubricate blades.
• Straighten blade or blade support.
• Straighten teeth.
• Tighten blade bolts.
• Check battery installation.
• Check battery charging requirements.
• Check that lock off is fully pulled back
prior to moving main trigger.
• Insert battery into charger until green LED
appears. Charge up to 8 hours if battery
totally drained.
• Plug charger into a working outlet. Refer
to "Important Charging Notes" for more
details.
• Check current at receptacle by plugging
in a lamp or other appliance.
• Check to see if receptacle is connected
to a light switch which turns power off
when you turn out the lights.
• Move charger and tool to a surrounding
air temperature of above 40 degree F
(4.5°C) or below 105 degree F (40.5°C).
Craftsman,
11