Features; Product Specifications; Assembly - RIDGID R87547 Manual Del Operador

FEATURES

PRODUCT SPECIFICATIONS

Cutting Wheel Diameter ............................................... 3 in.
Max Cutting Depth .................................................. 0.64 in.
Arbor Size ................................................................ 7/16 in.

ASSEMBLY

UNPACKING
This product requires assembly.
 Carefully remove the tool and any accessories from the
box. All items listed in the Includes section must be
included at the time of purchase.
WARNING:
Items in this Assembly section are not assembled
to the product by the manufacturer and require
customer installation. Use of a product that may
have been improperly assembled could result in
serious personal injury.
 Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
 Do not discard the packing material until you have
carefully inspected and satisfactorily operated the tool.
 If any parts are damaged or missing, please call
1-866-539-1710 for assistance.
WARNING:
If any parts are damaged or missing do not operate
this product until the parts are replaced. Use of
this product with damaged or missing parts could
result in serious personal injury.
WARNING:
Do not attempt to modify this product or create
accessories not recommended for use with this
product. Any such alteration or modification is
misuse and could result in a hazardous condition
leading to possible serious personal injury.
WARNING:
To prevent accidental starting that could cause
serious personal injury, always remove the battery
pack from the product when assembling parts.
Rated Speed ......................................... 20,000 /min (RPM)
Maximum Wheel Thickness ................................... 7/64 in.
Wheel Type .....................................Diamond and Abrasive
SELECTING CUTTING WHEEL
Selecting the correct type of wheel is important in order to
obtain the best performance from the saw. Select the wheel
based on the application and on the material you wish to
cut. Selecting the right wheel will give you a smoother, faster
cut and prolong the life of the wheel.
The best of cutting wheels will not cut efficiently if they are
not kept clean and sharp. Using a dull wheel will place a
heavy load on the saw and increase the danger of kickback.
Keep extra wheels on hand, so that sharp wheels are always
available.
Always carefully select and use cutting wheels that are
recommended for the material being cut. Make sure that the
minimum operating speed of any accessory wheel selected
is 22,500 /min. or more.
WARNING:
Never use grinding wheels of any kind with this
saw. Use of non-cutting wheels can result in
property damage or serious personal injury.
INSTALLING THE SHOE ASSEMBLY
See Figure 1, page 13.
 Remove the battery pack from the saw.
 Remove the 4 mm hex key from the storage area.
 Loosen the clamp screw completely and remove the
clamp.
 Place the shoe on the back of the wheel guard as shown
 Align the threaded hole on the wheel guard with the screw
in the clamp.
 Place the clamp onto the wheel guard and tighten the
screw to secure in place.
 Return the 4 mm hex key to the storage area.
To remove:
 Remove the battery pack from the saw.
 Remove the 4 mm hex key from the storage area.
 Loosen the clamp screw completely and remove the
clamp.
 Lift the shoe up and away from the wheel guard.
 Replace the clamp and clamp screw.
 Return the 4 mm hex key to the storage area.
7 - English