DeWalt DCS570 Manual De Instrucciones página 11

OPERATION

WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
Installing and Removing the Battery Pack
(Fig. D)
nOTE: For best results, make sure your battery pack is
fully charged.
To install the battery pack 3
battery pack with the rails inside the tool's handle and slide
it into the handle until the battery pack is firmly seated in
the tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release
button and firmly pull the battery pack out of the tool
13
handle. Insert it into the charger as described in the charger
section of this manual.
Fig. D
13
Worklight (Fig. A)

CAUTION: Do not stare into worklight. Serious eye
injury could result.
There is a worklight 15 located just below the blade lock
button 11 . The worklight is activated when the trigger
switch is depressed, and will automatically turn off 20
seconds after the trigger switch is released. If the trigger
switch remains depressed, the worklight will remain on.
nOTE: The worklight is for lighting the immediate work
surface and is not intended to be used as a flashlight.
Trigger Switch (Fig. E)

WARNING: This tool has no provision to lock the
trigger switch in the ON position and should never be
locked ON by any other means.
Release the trigger switch lock-off button
the button as shown. Pull the trigger switch
motor on. Releasing the trigger switch turns the motor off.
into the tool handle, align the
3
1 by pressing
2 to turn the
Fig. E
1
2
Changing Blades (Fig. F, G, H)

WARNING: Remove battery from tool before
changing blades.
To install the Blade (Fig. F, G, H)
1. Retract the lower blade guard
retracting lever 6 and place the blade on the saw
spindle against the inner clamp washer, making sure
that the blade will rotate in the proper direction (the
direction of the rotation arrow on the saw blade and the
teeth must point in the same direction as the direction
of rotation arrow on the lower blade guard). Do not
assume that the printing on the blade will always be
facing you when properly installed. When retracting
the lower blade guard to install the blade, check the
condition and operation of the lower blade guard to
assure that it is working properly. Make sure it moves
freely and does not touch the blade or any other part, in
all angles and depths of cut.
2. Place outer clamp washer
large flat surface against the blade with beveled side
facing out.
3. Thread blade clamping screw
hand (screw has right-hand threads and must be turned
clockwise to tighten).
4. Depress the blade lock button
saw spindle with the blade wrench (
the blade lock engages and the blade stops rotating.
5. Tighten the blade clamping screw firmly with the blade
wrench.
nOTE: Never engage the blade lock while saw is running,
or engage in an effort to stop the tool. Never turn the saw
on while the blade lock is engaged. Serious damage to your
saw will result.
English
7 using the lower blade
on saw spindle with the
16
8 into saw spindle by
11 while turning the
, Fig. G, H) until
14
9