Use; Charging Devices Using The Usb Port; Charging Laptops With A 19 V Charger Adapter; Using The Jump Start Booster As A Jump Starter - ProCharger 10011076 Instrucciones De Uso

Mains charger
1. Connect the coaxial power connector of the mains charger 10 to the mains
plug port 2.
2. Connect the mains plug of the mains charger to a properly installed power
outlet.
Vehicle charger
1. Connect the vehicle charger 11 to the 12 V vehicle power outlet.
2. Connect the cable of the cigarette lighter plug to the mains plug port 2.
The LEDs of the charge level indicator fl ash 8 and indicate the charge status
during the charging process.
Once all the LEDs light up constantly, the battery pack is fully charged. The
charging cable then has to be disconnected from the mains power.
The battery pack cannot be charged while an electronic device is being
charged by the battery pack at the same time.
5.3 | Checking the charge status of the battery pack
The fi ve LEDs of the charge status display 8 show the battery pack's remaining
charge level. When you press the function key 1, the charge level is displayed for
a few seconds. While you are charging a device, the LEDs indicate the remaining
charge level of the battery pack.
Charge level Charge level indicator
100% All fi ve LEDs light up.
80% Four LEDs light up.
60% Three LEDs light up.
40% Two LEDs light up.
20% One LED lights up.
< 20% One LED fl ashes.

6 | Use

6.1 | Charging devices using the USB port

1. Insert the charger adapter cable 13 into the USB port 3 (see Fig. 4) with 2.1 A
26
or into the USB port 4 with 1.0 A.
2. Connect the device you wish to charge to a suitable plug on the charger
adapter cable 13.
The charge level indicator 8 indicates the charge level of the battery pack.
3. On completion of the charging process, disconnect the device being charged
from the multi adapter.
You can also connect two devices at the same time by connecting one
device to the USB port 3 and another device to the USB port 4.
6.2 | Charging laptops with a 19 V charger adapter
1. Insert the adapter cable of the 19 V charger adapter 12 into the 19 V charger
port 5 (see Fig. 5).
2. Select the appropriate adapter 12 for your laptop and connect it to the
adapter cable.
3. Connect the adapter to the charger port on your laptop.
4. On completion of the charging process, disconnect the laptop from the
adapter cable.

6.3 | Using the jump start booster as a jump starter

WARNING!
Risk of fire electric shock and fire!
Incorrect use of the jump start cable increases the risk of
electric shock and fi re.
• Always wear suitable work clothing, protective gloves and
protective goggles when you work on a vehicle battery.
• Remove metallic objects (e.g. rings, watches, necklaces)
before the jump starting process.
• Never connect the black cable to fuel lines, injection systems
or similar parts which come into contact with fuel.
• Do not allow the contacts of the terminals to come into
contact with each other as there is otherwise a risk of a short
circuit.
The battery pack should always be fully charged before it is used as a jump
starter so that the best possible jump start power can be provided.
The battery pack must not be used as a jump starter if less than 4 LEDs of the
charge level indicator 8 are lit.
27