Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Range Installation
The back of the range may be installed directly
against the wall.
To reduce possible scorching of vertical walls and to
minimize potential fire hazards under abnormal
surface unit use conditions such as high heat or no
pans and to conform to A.G.A. requirements, a
minimum of 2 I/2" (6.4 cm) spacing should be
provided on both sides of the cooktop.
8,2 Check Operation
Refer to the Use and Care Guide and the Electronic Oven
Control Guide packaged with the range for operating
instructions and for care and cleaning of your range.
Remove all packaging from the oven before testing.
I.
Install Burner Bases and Burner Caps
This range is equipped with sealed burners as shown
(see Figure 1 I).
Excessive
Weight
Hazard
• Use 2 or more
people
to move
and install
range.
• Failure
to follow
this instruction
can result
in
back or other injury.
8.1 Leveling
the Range
1.
Install an oven rack in the center of the oven.
2.
Place a level on the rack (see Figure 10). Take 2
readings with the level placed diagonally in one
direction and then the other. Level the range, if
necessary, by adjusting the 4 leveling legs with a
wrench (see Figure 15).
3.
Slide the range to its final position and double check
for levelness. If the range is not level, pull unit out
and readjust leveling legs, or make sure floor is
level.
Figure 10
Figure 11
a.
Unpack burner bases and burner caps.
b.
Place burner bases over each gas opening.
c.
Make sure the burner is properly
aligned and
leveled.
Place burner
caps over appropriate
burner bases.
NOTE: There are no burner adjustments necessary
on this range.
2.
Turn on Electrical Power and Open Main Shutoff
Gas Valve
.
Check the Igniters
Operation of electric igniters should be checked after
range and supply line connectors have been carefully
checked for leaks and range has been connected to
electric power. To check for proper lighting:
a.
Push in and turn a surface burner knob to the
LITE position. All electronic surface ignitors will
spark at the same time. However, only the
burner you are turning on will ignite.
b.
The surface burner should light once the flow of
gas reached the surface burner. Each burner
should light within four (4) seconds in normal
operation after air has been purged from supply
lines. Visually check that burner has lit.
c.
Once the burner lights, the control knob should
be rotated out of the LITE position.
There are separate ignition devices for each burner.
Try each knob separately until all burner valves have
been checked.
Publicidad
Tabla de contenido
