Range Installation; Leveling The Range; Check Operation - Sears Kenmore Pro 79079523605 Instrucciones De Instalación

30" DUAL FUEL RANGE INSTALLATION INSTRUCTIONS
8.

Range Installation

1. The back of the range may be installed directly
against the wall.
2. To reduce possible scorching of vertical walls and
to minimize potential fire hazards under abnormal
surface unit use conditions such as high heat or
no pans and to conform to A.G.A. requirements,
a minimum of 2 1/2" (6.4 cm) spacing should be
provided on both sides of the cooktop.
Excessive Weight Hazard
• Use 2 or more people to move and install
range.
• Failure to follow this instruction can result in
back or other injury.

8.1 Leveling the Range

1. Install an oven rack in the center of the oven.
2. Place a level on the rack (see Figure 10). Take 2
readings with the level placed diagonally in one
direction and then the other. Level the range, if
necessary, by adjusting the 4 leveling legs with a
wrench (see Figure 21).
3. Slide the range to its final position and double check
for levelness. If the range is not level, pull unit out
and readjust leveling legs, or make sure floor is level.
Figure 10
(Model with Electric Oven and Gas Cooktop)

8.2 Check Operation

Refer to the Use and Care Guide packaged with the
cooktop for operating instructions and for care and
cleaning of your cooktop.
Do not touch the burners. They may
be hot enough to cause burns.
1.Install Burner Caps
Round Style Burners
This cooktop is equipped with sealed burners. All pieces
are at their place. Take note where they are. Remove
all packaging material. Make sure the burner caps are
properly aligned and leveled. The burner cap lip (See
Figure 11) should fit snug into the center of burner head
and rest level. Refer to Figures 12 & 13 for correct and
incorrect burner cap placement. Once in place, you may
check the fit by gently sliding the burner cap from side
to side (Figure 14) to be sure it is centered and firmly
seated. When the burner cap lip makes contact inside
the center of the burner head you will be able to feel it.
Please note that the burner cap should NOT move off the
center of the burner head when sliding from side to side.
NOTE: There are no burner adjustments necessary on
this cooktop.
Burner Cap
Burner Head
Correct Burner Cap
Placement - Fig. 12
8
Burner Cap
Lip
Fig. 11
Incorrect Burner Cap
Placement - Fig. 13
Fig. 14