Electrical Specifications - Admiral AAWV-12CR1FAU Manual De Uso Y Mantenimiento

AC 12 10 8 6 MAN final

ELECTRICAL SPECIFICATIONS

1. All wiring must comply with local and national
electrical codes and must be installed by a
licensed electrician. Once you have any questions
regarding the following instructions, contact a
licensed electrician.
2. Check available power supply and resolve any
wiring problems BEFORE installing and operating
this unit.
3. For your safety and protection. This unit is
grounded through the power cord when
plugged into a matching wall outlet. If you are
not sure whether your wall outlet is properly
grounded, please consult a licensed
electrician.
4. The wall outlet(3-pin) must match the plug
(3-pin) on the service cord supplied with the unit.
DO NOT use plug adapters or extension cord.
See (Table 1) for receptacle and fuse information.
5. The rating plate on the unit contains electrical
and other technical data. The rating plate is located
on the right side of the unit.
3/2/05 12:55 PM Page 7
Electric Shock Hazard
If the air conditioner has a serial plate rating
of 115 volts and up to and including 7.5 amps
the unit maybe on a fuse or circuit breaker
with other devices. However, the maximum
amps of all devices on that fuse or circuit
breaker can not exceed the amps of the fuse
of circuit breaker.
If the air conditioner has a serial plate rating
of 115 volts and greater than 7.5 amps it
must have its own fuse or circuit breaker,
and no other device or unit should be
operated on the fuse or circuit breaker.
To avoid the possibility of personal injury,
disconnect power to the unit before installing
or servicing.
Receptacle and Fuse Types
Rated Volts
AMPS
Wall Outlet
Fuse Size
Time Delay Fuse
(or circuit breaker)
5
125
15
15
Plug type
Table 1