Tips Before Installation - Admiral AAWV-12CR1FAU Manual De Uso Y Mantenimiento

AC 12 10 8 6 MAN final

TIPS BEFORE INSTALLATION

Your Room Air Conditioner unit is designed to
be highly efficient and save energy. Follow these
recommendations for greater efficiency.
1. Select the thermostat setting that suits your
comfort needs and leave the thermostat at
that chosen setting.
2. The filter is very efficient in removing airborne
particles. Keep air filter clean. Normally, filter
should be cleaned once a month. More
frequent cleaning may be necessary depending
on outdoor and indoor air quality.
3. Use drapes, curtains, or shades to keep
direct sunlight from heating your room, but
DO NOT obstruct the air conditioner. Allow air to
circulate around the unit without obstructions.
4. Start your air conditioner before outdoor
air becomes hot and uncomfortable. This
avoids an initial period of discomfort while
the unit is cooling off the room.
5. When outdoor temperature is cool
enough, use HIGH or LOW FAN
only. This circulates indoor air, providing
some cooling comfort, and utilizes less
electricity than when operating on a
cooling setting.
!
To avoid installation/operating difficulties,
read the instructions thoroughly.
Your Room Air Conditioner was designed for
easy installation in a vertical (slider type) windows.
NOTE: This unit is NOT designed for single
or double-hung windows.
3/2/05 12:55 PM Page 8
CAUTION
!
NOTE: Save the shipping carton and packing
materials for future storage or transport of the unit.
Please check the contents of hardware kit against
the corresponding model check list, prior to
installation of the unit. See lists below.(Fig.A)
Fig. A Installation Hardware
Fig. 1A Installation Hardware Model 463AAC008BA
3/8"Screws (4)
1"Screws (2)
7/16" Screws(2)
Support
platform(1)
Speed clips(2)
Support angles (1)
Top channel(1)
Factory installed
Bottom bar(1)
Factory installed
Top retainer (1)
Foam (1)
NOTE: Surplus screw(s) for spare use.
Tools Needed for Window Installation
Screw drivers: Both Philips and flat head
Power drill: 1/8 inch diameter drill bit
Pencil
Measuring tape
Scissors
Carpenters level
6
Nuts(2)
Washers(2)
End Cap &
Leveling Leg (1)
Filler panel(1)
Side
channels(2)
Factory installed
Sliders(2)
Shorter
seal (1)
Seals (2)
Side seals (2)
Factory installed