Installation Instructions - Admiral AAWV-12CR1FAU Manual De Uso Y Mantenimiento

AC 12 10 8 6 MAN final

INSTALLATION INSTRUCTIONS

A
7/16"Screws
Support
platform
B
Two 1" long self-tapping screws
Support platform
assembly
Lower window
track
C
Seal
Shorter seal
3/2/05 12:55 PM Page 9
Support angle
Leveling bolt
Top retainer
Filler panel
Sliders
Sliding Window Installation
1.Choose the installation site. It is imperative that the window
frame assembly and the side of the structure are adequate to
support the weight of the unit. Reinforce if necessary.
2.Slide open one window sash to install support platform.
3.Loosely attach support angle to bottom of support platform
using two 7/16 screws, washers and nuts. "
4.Place support platform against lower window track and
firmly against vertical edge of window frame.
5.Attach support platform to window sill using two
self-tapping screws. To overcome interference of support the
Platform with window track or storm window, securely attach
a 2 wide shim strip to the window sill. The strip should be as
"
long as the width of the support platform and flush with the back
edge of the sill. The thickness of the strip should be controlled
by the amount of interference.(See fig. B)
6.Pull support angle against outside of structure. Tighten two
7/16 screws on top of the support platform. "
7.Adjust leveling bolt to position support angle in a level
plane. This will allow for the proper angle. Tighten leveling
bolt locknut.
Important: Unit must be level or tilted back slightly to
facilitate proper condensate disposal.
Caution: Do not drill a hole in the bottom pan. The unit
is designed to operate with approximate
water in the bottom pan.
8.Cut two pieces of adhesive seal to height of window
opening. Remove backing and apply tovertical inside
edges of window frame and sliding sash that will rest
against unit.(See fig. C)
9.Slide unit onto support platform. Be sure unit side
channel butts against vertical edge of window frame.
Note: If unit side channel does not fit securely,
remove unit and readjust leveling bolt.
10.Drill two 1/8 holes through window channel frame 10.Drill two 1/8 holes through window channel frame " "
in alignment with existing holes in bottom bar. Install
two 3/8 long self-tapping screws through these holes.
"
If the window channel frame is not tall enough to use
existing holes, drill new holes off to the side of the
existing holes to attach the unit bottom bar to the
support platform.The unit should be firmly anchored to the
window channel frame or support platform.(See fig. D)
11.Slide inside window sash closed. Be sure vertical edge
of inside window sash is pressed firmly against side of unit
cabinet. Cut remaining seal to width of window opening.
Remove backing and apply to top inside edge of window
frame.(See fig. C)
The above installations are intended to be permanent,
and when installed in apartment or rental properties,
permission to make the above modifications should be
obtained from owners or landlords of buildings prior
to installation of unit.
7
(See fig. A)
1 "
ly 1/2 " of