Installation In The Laboratory; Environmental Operating Conditions - Caframo BDC2002 Manual De Instrucciones

Installation In The Laboratory

Installing the support bar
Remove the allen screw and lock washer from the support bar . Insert the support
bar into the back of the stirrer so that the holes line up for the allen screw . secure
with allen screw and lock washer and tighten with allen key .
Clamp the stirrer to a Caframo stand on a stable, level surface . see safety
Instructions .
Connect stirrer to supplied Caframo power supply . Connect power supply to a
grounded electrical outlet .
Impeller attachment
Insert the impeller shaft into the open chuck and adjust the impeller to the desired
height . The hollow shaft allows the impeller shaft to come through the top of the
stirrer if necessary .
CAUTIOn:
Operating a freely rotating impeller shaft through the top of the
stirrer is not safe . Do not allow the impeller shaft to touch or
extend through the rubber gasket while the motor is powered on .
The gasket is for sealing purposes only . Tighten the chuck's outer
ring by hand and then secure with the chuck key .

Environmental Operating Conditions

The BDC2002 and BDC2010 stirrers must operate in the following conditions:
Indoors
1 . Altitudes up to 2000 m (6500 ft .) .
2 . Temperatures from 5
3 . Maximum relative humidity 80% for temperatures up to 31
linearly to 50% relative humidity at 40
4 . Pollution degree 2 in accordance with IeC 664
"normally only non conductive pollution occurs . Occasionally,
however, temporary conductivity caused by condensation must
be expected ."
C to 40 C (41 F to 104
o o o
13
F) .
o
C (104 F) .
o o
C (88 F) decreasing
o o