Caframo BDC2002 Manual De Instrucciones página 18

When the stirrer is powered on, the default speed is 40 rpm, countdown timer
is 0 minutes, and the xRx agitation cycle is 0 seconds .
If the stirrer is kept powered on it will remember the original values set for speed,
the countdown timer and the x
button is pressed again the operations will repeat .
speed can be changed (increased or decreased) while the stirrer is running . Press
the multifunction button so the speed is displayed . Increase or decrease speed by
pressing the "+" or "-" buttons .
The countdown timer and the x
the stirrer is stopped and the indicator lights are solid . If the indicator lights are
flashing the parameters cannot be changed . To reset the stirrer, power the stirrer
off and then on again .
The multifunction button can be pressed when the stirrer is running to check the
status of each function .
For safety, a "soft start" has been incorporated into the stirrer . The stirrer will
ramp up to reach the set speed to minimize splashing .
In the event of a power outage, the stirrer will stop and set parameters will go back
to their default values .
Display Codes
Ol Indicates an overload condition . The load is too great for the stirrer and
must be reduced . Press the power button and enter in new parameters
and start .
Oh Indicates an overheat condition . The operating conditions have caused
the stirrer to overheat . Reduce stirrer loads and/or environmental tem-
perature to continue mixing . To reset stirrer turn power off, allow stirrer
to cool and then turn back on .
x agitation cycle so that when the start/pause
R
x agitation cycle can be changed only when
R
18