Selecting Syncro Start Characteristics - Miller Syncrowave 200 Manual Del Propietário Y Guía

3-9. Selecting Syncro Start Characteristics

1
4
3
0000 0000
1 Power Switch
2 Main Amps Control
3 Volt And Ammeters
4 Process Selector Switch
To change TIG HF Syncro starting char-
acteristics, turn Off power, place Output
Selector switch in desired position,
DCEN, DCEP or AC. Each position has
three start characteristics options. Push
and hold Main Amps button and turn on
power. Hold button for approximately 7
seconds.
Meters will display [AC] [MED] or [DCEN]
[MED], or [DCEP] [MED], depending on posi-
2
tion of Output Selector switch
Turn Encoder to step through the three
start characteristics choices. Ammeter
displays active choice: soft start, me-
dium start, or hot start.
Change polarity (see Section 3-1) to set
values for each TIG output. Each setting
is polarity specific.
Press torch trigger or turn off power to
save settings.
Application:
Soft start - use for thin gauge material
and small diameter
(.040−1/16 in)
Medium start - factory-set default, used
for most welding applications with a 1/16,
3/32 or 1/8 in. tungsten.
Hot start - use for thick materials with a
large diameter tungsten (1/8−5/32 in.).
OM-225 389 Page 21
tungstens