DBI SALA 3400101 Manual De Istrucciones página 26

IMPORTANT: Operating the retrieval system at loads greater than
the rated capacity reduces the overall safety factor. Any unit which
has been used above the rated capacity must be removed from
service and returned to Capital Safety for inspection.
◊ Mounting Retrieval Models: The SRL retrieval models as
shown in fi gure 1 and 2, may be used with optional brackets
(Capital Safety Part Numbers 3401123 and 3401090) for mount-
ing to the Capital Safety tripod, davit arm, or ladder mast. Fol-
low the steps below for mounting and use of these brackets.
IMPORTANT: If mating bracket for tripod leg is not attached,
position clamp plate assembly in desired location on leg and tighten
bolts to 20 Nm. Do not overtighten.
Step 1. Attach the bracket to the SRL by inserting the two
Step 2. After the bracket is secured to the SRL, position the
Step 3. With assembly resting on pin, pivot top of SRL inward
Step 4. Extend cable up support structure and over pulleys.
• RETRIEVAL SYSTEM OPERATION (MODELS 340854 AND
340855) (EN360:2002 AND EN1496:2006 CLASSES A,B): Figure
4 identifi es key components of the retrieval system. To activate
retrieval mode, rotate the locking screw (D) down completely to
free the crank arm (E). Pivot the handle (A) out from the stowed
position. To engage the winch, pull and hold the shift knob (C) in
the unlocked position. Push the crank arm (E) in to the engaged
position and release the shift knob (C). If needed, rotate the crank
arm clockwise (lowering) to aid in gear engagement.
◊ To Raise: Rotate the crank arm counterclockwise. The rescue
lifting device shall only be used if an unhindered lifting process
is possible and that it shall not be used if obstacles present an
hazard.
furnished bolts through the holes in the SRL housing.
Attach nuts and secure. See Figure 18.
SRL bracket assembly onto mating bracket of tripod,
davit arm, or ladder mast. The slot in the end of SRL
bracket slides onto the pin extending out each side of
the mating bracket. Reposition the tripod leg bracket
as required for proper operating height. See Figure 19.
to align holes. Press in button on the end of the detent
pin and slide pin in fully to secure SRL assembly to
tripod, davit arm, or ladder mast. See Figure 20.
Reinstall detent pins near pulley to prevent cable from
sliding off pulleys. See Figure 21. Figures 22 and 23
show a completed attachment.
26