Lincoln Electric WF24 Manual De Instrucciones página 10

4. Digital Display Panel.
WF24S:

Display A: It shows the actual welding current value
(in A), and after finishing welding process, it shows the
average value of the welding current. When the WFS
value is changed [2], the display shows the value of
adjusted WFS (in m/min) - for manual mode or
correction of the speed automatically matched by the
machine, in the range 0.75-1.25 at synergic mode.

Display V: It shows the actual value of welding
voltage (in V), and after finishing welding process, it
shows the average value of welding voltage. When
the WFS value is changed [2], the display is blank.

Work Indicators: These lamps shows the work mode
of the machine:
When lit, the machine works in Synergic
SYNERGIC
mode (automatic mode).
When lit, the machine works in Manual
mode.
Select the desired work with the "Welding Material and
Gas Mix Choice Knob" [11].
WF24:

Display A: It shows the actual welding current value
(in A), and after finishing welding process, it shows the
average value of the welding current.

Display V: It shows the actual value of welding
voltage (in V), and after finishing welding process, it
shows the average value of welding voltage.
5. Quick Connect Couplings (For water cooled model
only): For connecting water cooled torches.
Warm water from torch.
Cool water to torch.
Figure 2.
English
6. Quick Connect Couplings (For water cooled model
only): If water cooled torches are used, connect water
lines from water cooler here. Refer to torch and water
cooler guidelines for recommended cooling liquid and
flow rates.
Max cooling liquid pressure is 4 Bar.
7. Fast-Mate Adapter: Input power connection.
8. Gas Connector: Connection for gas line.
9. Amphenol Connection:
source.
10. Wire Diameter Knob: It allows the choice of the wire
diameter requested for the desired welding process.
This feature is available only for the synergic mode.
11. Welding Material and Gas Mix Choice Knob: This
knob enables the choice of:
- The welded material and its appropriate gas mixture.
- The manual / synergic work mode.
12. Wire Feed Slow Run Control Knob: It enables control
of wire feeding speed before welding beginning, in the
range from 0.1 to1.0 of the value set by the "Wire
Feed Speed Control Knob" [2].
6
WARNING
8-Pin connection to power
Figure 3.
Figure 4.
English