Insertion Tool; Selecting The Right Insertion Tool; Narrow Chisel; Moil Point - Cobra PRO Instrucciones De Seguridad Y De Funcionamiento

COBRA PRO, TT, TT-AWD
DANGER Run over
If the stop function is not working, it can result in
serious injuries or death.
Before using the Audio Warning Device test the
►
function of the warning equipment.
► If the stop function is not working, contact your
nearest authorised workshop.
Checking the stop function
1. Check that plug (B) is fitted to outlet (A), so the
machine is in order to start.
2. Start the machine and then pull out the plug (B).
The machine shall stop immediately. If the
machine does not stop when the plug (B) is
removed, it must under no circumstances be
used together with Audio Warning device. For
further instructions contact your nearest
authorised workshop.

Insertion tool

CAUTION Hot insertion tool
The tip of the insertion tool can become hot and
sharp when used. Touching it can lead to burns and
cuts.
Never touch a hot or sharp insertion tool.
►
► Wait until the insertion tool has cooled down before
carrying out maintenance work.
© 2010 Atlas Copco Construction Tools AB | No. 9800 0956 90a | 2010-01-01
Original instructions
Safety and operating instructions
NOTICE Never cool a hot insertion tool in water, it
can result in brittleness and early failure.

Selecting the right insertion tool

Selecting the right insertion tool is a precondition for
proper machine function. It is important to select
insertion tools of high quality to avoid unnecessary
machine damage.
The machine can be destroyed if you use an incorrect
insertion tool.
Recommended insertion tools are listed in the
machine's spare parts list.

Narrow chisel

Moil point

Wide bladed chisel

WARNING Vibration hazard
Using inserted tools that do not fulfil the criterias
mentioned below, will result in a longer time to
complete a task, and may result in higher levels of
vibration exposure. A worn tool will also cause
increased working time.
Make sure that the inserted tool is well-maintained,
►
not worn out and of the proper size.
► Always use a sharp tool in order to work efficiently.
The narrow chisel is used for
demolition and cutting work in
concrete and other types of
hard materials.
The moil point is only used for
making holes in concrete and
other types of hard materials.
The wide bladed chisel is used
in soft materials, such as
asphalt and frozen ground.
17