Multiquick Clamp - Bosch FWA 4310 Instrucciones De Funcionamiento

4 .7 .2

Multiquick clamp

i
Remove the wheel caps if necessary and clean the
rims and pin holes for the clamps.
Make sure that
R
The clamps are firmly attached to the tire
R
The clamping jaws engage properly in the tread
R
The coated securing hook is engaged in the upper
part of the rim.
Multiquick clamps permit two types of attachment.
a) Use of standard spacers and sleeves:
i
The sleeves are intended for Softline rims and are
fitted over the spacers.
1. Position the clamp with the stop pins in the rim flan-
ge, move the upper one to the rim flange and secure.
2. Press both clamping levers towards the wheel until
they are parallel with the wheel.
At the same time press both clamping arms onto the
3.
tread and release the clamping levers. The adjustab-
le clamping arms are to be set such that they engage
firmly in the tread.
4. After securing, pull out the plug-in handles of the
front clamping levers.
Fig. 16: Multiquick clamp
Robert Bosch GmbH
Operation | FWA 43xx / 44xx | 33
b) Use of vehicle-specific spacer pins and adapters:
1. Clean the mounting holes for the spacer pins and
adapters..
2. Attach the spacer pins or adapters.
3. At the same time press both clamping arms onto the
tread and release the clamping levers. The adjustab-
le clamping arms are to be set such that they engage
firmly in the tread.
4. After securing, pull out the plug-in handles of the
front clamping levers.
i
The brake disc fixing screw must be tightened and
must not protrude above the surface of the equip-
ment.
i
If a spacer pin "tips over" in the bolt or hole for
handbrake setting, it is to be moved to "12 o'clock
position".
Re-position the spacer pins to suit the 4 or 5-hole
rims or use adapters. Clean the pin hole and insert
the feelers in the rim hole.
i
When using the universal standard accessories,
run-out compensation is only necessary
R
If rim damage is suspected
R
In the event of defective clamps
R
If specified by the motor vehicle manufacturer.
Run-out compensation is not required when using the
vehicle-specific accessories.
FWA 43xx / 44xx | 33 | 33
|
1 690 326 001 2008-09-17
en