Clean Thetransfer Ribbon Drawing Roller; Clean The Printhead; Clean The Label Photocell - Carl Valentin SPX II Serie Instrucciones Abreviadas Y Recomendaciones De Seguridad

Clean theTransfer Ribbon Drawing Roller

A soiled drawing roller can lead to reduced print quality and can affect transport of material.
•
Open the cover of print module.
•
Remove labels and transfer ribbon from the print mechanics.
•
Remove deposits with the roller cleaner and a soft cloth.
•
If the roller appears damaged, replace it.

Clean the Printhead

CAUTION!
Wrong cleaning auxiliaries can damage the printhead!

Do not use sharp or hard objects to clean the printhead.

Do not touch protective glass layer of the printhead.
Printing can cause accumulation of dirt at printhead e.g. by colour particles of transfer ribbon, and therefore it is necessary to
clean the printhead in regular periods depending on operating hours, environmental effects such as dust etc.
•
Open the cover of print module.
•
Turn the lever counter clockwise to lift up the printhead.
•
Remove labels and transfer ribbon from the print mechanics.
•
Clean the printhead surface with a special cleaning pen or a cotton swab dipped in pure alcohol.
•
Before using the printing system, let the printhead dry for about two to three minutes.

Clean the Label Photocell

CAUTION!
Abrasive cleaning agents can damage the label photocell.

Do not use sharp or hard objects or solvents to clean the label photocell.
The label photocell can be soiled with paper dust. This may affect the label scanning.
A
•
Open the cover of print module.
•
Turn the lever counter clockwise to lift up the printhead.
•
Remove labels and transfer ribbon from the print
mechanics.
•
Blow out the photocell (A) with the compressed air
B
spray. You have strictly to observe the instructions
mentioned on the can.
•
Moisten a cleaning card (B) with printhead and roll
solvent to clean additionally the photocell inside.
•
Reload labels and transfer ribbon.
English
SPX II
137