Fluval PROFILE 850 Manual De Instrucciones página 10

Output system installation
1. Slip connector stem (A) fully through opening (O) until it stops (ill. 1)
2. Open the cabinet. Screw and tighten the ring nut (R) onto the bottom
end of stem (A) (ill. 2).
3. Insert the output nozzle (N) into one end of outlet stem (B)
4. Insert output stem (B) in connector stem (A) (ill. 3).
CONNECTOR
STEM (A)
5. Regulate the height of the output nozzles according to your requirement
by sliding output stem (B) along connector stem (A).
6. The output nozzles (N) can be easily rotated to divert the water flow
where desired.
Direct the water jets so as not to let water overflow from the tank.
Avoid directing the water jets toward the Strip-Light(s) of the canopy.
ill. 1
Intake system installation
1. Slip the second connector stem (A) fully through opening (I) until it stops (ill. 1).
2. Open the cabinet. Screw and tighten the nut ring (R) onto the bottom end of the second stem (A) (illl. 2).
3. Insert the intake strainer (S) in connector stem (A) (ill. 4).
The height of the intake strainer is high enough to suit most standard aquarium decorations. When decorating the
aquarium, ensure that the intake strainer remains at least 5 cm (2") from the gravel bottom at all times to prevent it
from sucking gravel or sand. Ensure that decorations do not block the flow of water. Ornaments and rocks should be
placed while the aquarium is still dry.
CAUTION! Never force Connector Stems (A) sideways, as this may damage the output/input systems and the
glass tank.
OUTPUT
STEM (B)
OUTPUT
NOZZLE (N)
INTAKE
RING NUT (R)
STRAINER (S)
ill. 2 ill. 3 ill. 4 ill. 5
7