Section #6; Maintenance - Fluval PROFILE 850 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

SAVE THESE INSTRUCTIONS.
For the complete use and understanding of this product, it is recommended that this
manual is thoroughly read and understood. Failure to do so may result in damage to
this product.
PREPARING AND INSTALLING THE STRIP-LIGHTS
All PROFILE Aquarium models feature 2 Strip-Lights each. Each Strip-Light will feature
two (2) T5HO fluorescent bulbs. The GLO T5HO lamps supplied require installation into
each strip light.
ill. 6
1. Unscrew the lamp holder threaded fitting with one hand while supporting the lamp holder with the
other hand (to prevent accidental cracking of this plastic component). This procedure must be performed at both
ends of each Strip-Light.
2. Slide the two threaded fittings with gaskets onto the fluorescent tube, towards the middle, so that the threads are
facing the ends of the fluorescent bulb (as shown in ill. 6).
Ensure that the gaskets are properly positioned.
3. Carefully align and insert the pins of the new fluorescent tube into the lamp holder slots at each end of
the Strip-Light.
CORRECT
INCORRECT
3A. Twist the fluorescent tubes 1/4 turn or 90°. Until the
lamps have "clicked" into place.
4. Carefully support the lamp holders with one hand and
gently screw the threaded fittings with the other hand.
Firmly hand-tighten these fittings, the use of any tool is not
recommended. Ensure that the end caps are completely
threaded onto the lamp holders. These units are plastic, avoid
cross-threading the fittings.
ill. 7
5. Place the Strip-Light back onto the aquarium and position the 3 lids.
6. Repeat steps 1-4 for 2
fixture.
nd
WARNING: Ensure that there are no visible threads or gaps between the lamp
socket and threaded fittings. Ensure threaded fittings are not cross threaded onto the
lamp socket. (See ill. 7 )
The threaded fittings must be fully tightened to prevent moisture from entering the
socket and corroding the electrical contacts.
WARNING: The safety of this Strip-Light is guaranteed provided that both
lamps are inserted and that all threaded fittings are properly installed.
Replace the Strip-Light(s) first and then place the lids on the top frame to close the
aquarium completely.
DO NOT PLUG IN NOW. The Strip Light(s) is now ready for start-up, but it can be started only after you have
completely installed all aquarium accessories.

SECTION #6

MAINTENANCE

WARNING: Always disconnect all appliances in the aquarium from the electrical supply before placing
hands in the water, before putting on or taking off parts, and whenever the appliances are being installed,
maintained or handled.
1. AQUARIUM GLASS TANK CARE AND MAINTENANCE
The aquarium tank does not require particular maintenance, except regular cleaning. Special care should always
be taken not to damage the silicone seals while cleaning and maintaining your aquarium.
13

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Profile 1200Profile 1000Profile 1500

Tabla de contenido